Grass Yes's latest activity

A friend let me borrow their Tornado. Thought I would give my thoughts. My first impressions were poor. So I may as well run through...

I think the perfect iteration of this design would have two heated plates (like hot knives) and somehow smoosh them together. It’s...

I'm a patient. Got covid Sept, 2023. Couldn't get paxlovid, and weeks later it hadn't resolved. Turned into long covid (LC) and by...

Been following this thread and really wanting to try out a "Hash Pipe" but could not get any Hash in Southers Oregon. After months of...

Finally tried one of these, IDB sent a dual PID setup for wireless Vulcan and Epitome, just got set up for the E at least for now, using...

Not quite but close enough:

Haha yeah they are nothing like that now, big redesign with FW7 for more on demand hybrid conduction in ceramic chambers, keep an eye on...

No waste, bro, we're just happy to get you to where you need to be. Others will benefit from this too. It does indeed look off-center...

I measured the same as you 11-12mm from the top of the heater pôle to the top of the station. But you’re right with a vapman in place...

I think I'd need to see it from directly above with a vapman seated on it to see if it looked centered. The machining is a little rough...

Yes I have to try to move a little the heater to see if that helps, I’ll let you know if it’s better after this adjustement, thank you

This is probably it. I wonder if somehow the entire heater stand is propped up on an insulator or something, making it taller than it...

Interesting, the last FW I handled was the FW4, so it has been a while haha. Good idea, I hadn't considered that. 🤔

Perhaps your heater stand needs adjustment. It looks okay in the photos, but I suspect it would be hard to tell. I remember @coolbreeze...