Recent content by Gonchin

Yes, it does.

You are welcome. When you said you found a flaw, I had to intervene. I'm sure the manual will explain everything eventually. So far the only flaw I can find is my fault for liking this too much and increasing my tolerance.

Unscrew the mouthpiece from the the stem, remove the heat shield and inner-cooler. Slide the C-Shape tool onto one of the 2 sets of grooves located on the mouthpiece end of the stem. Use that to set to depth of the screen, depending on what groove you use.

If you have the V2 adapter try 525 until timeout with the default zirc balls. The V1 adapter is a higher temp, but I don't have one, so I'm not sure how much. Try 40ish. more.

If you look at this image on the Madheaters website, there is a metal tube on the left side of this picture. I wonder what that is? The new storage tube? No apparent threads or seams, just looks like a plain tube...lol

It is the c-shaped tool that is used to set the bowl screen depth.

I'm running the same temp with rubies. 525ºF with zirc.

Boo...I just opened the head to reload and the balls went scattering. I'm not sure why or how the screen got loose. I have been using it over a week since I last messed with the balls. I found most of them. I was thinking about throwing the rubies back in today anyway, but now I'm...

After I received my temp test 2, it took less that 24 hours to fall in love. I immediately decided I needed a carry case and wanted a wooden sleeve. So I went to madheaters site to order the leather case and sleeve. To my dismay, the wood sleeves that I drooled over the day before were out of...

Are you using an actual screwdriver with a handle? If not find a jeweler screwdriver set first and try that. It will loosen counterclockwise. If that does not help, try heating the tip. The heat may expand the hole enough to break it loose.

You may be the first person to report multiple heat cycles I have seen. Definitely the first who went 3 cycles. However, you do you and if that is what you are looking for, enjoy that new vape!

Thanks a lot! What about the part that screws onto the bowl? It that titanium? I love that fact that I can tear this down all the way. No major harm was done. I think a good polishing will bring it almost as good as new.

Well, If someone is able to confirm the material, I will go ahead and hit it with a torch as well. I scraped most of the melted plastic off, but I didn't want to scratch it up a bunch so I left a couple stubborn spots. I also didn't realize it was plastic I was dealing with until after I got if...

Thanks a lot. I did end up using a torch to burn most of it off. What I though was fabric from the comforter really ended up being melted plastic from the wand. I had to use an exacto blade to scrape off the Vi since Brenyo has mentioned that it can't take a lot of heat. Does anyone know what...

What's the best way to clean burnt gunk off the cap? I think the Tempest did it's job too well last night. My stoned ass must have forgotten to screw the cap to the tip. When I pulled it out of the wand, the cap fell onto my comforter. Surprisingly the comforter survived, but the cap is a mess...