Gomaruana's latest activity

Cool! I read up some more on the theory of IH, and I think that you are right to start on a higher frequency. This page explains a lot...

I was more thinking in the lines of finding a way to avoid the situation where there is too much metal inserted and the circuit can't...

I've been getting interested in induction heater design too :science:. After looking into it, the common circuit used on the cheap blue...

Very cool! Reminds me of my build, I should look if I still have some images from it. I'm was using it to heat up a full sized ballvape...

Close enough? Or exactly the same?

that looks great too bad it's not on dhgate, I'm in europe

Just snagged this and thought I'd share. Seems like a pretty good deal shipping from CA. https://www.ebay.com/itm/385200742388 Also...

I'd think you want a low frequency. Turning on the ZVS induces huge power spikes, when I did my pid temp controlled induction heater...

It's a Cloud Connoisseur Atlas: https://fuckcombustion.com/threads/atlas-by-cloud-connoisseur-idb.51574/ It's a cartridge heater...

how is that injector heated up? Looks really nice

Just ordered this guy (18mm 90degree version), I'm going to 3d print a base for it and use it with an 18mm female whip adapter. Most...

I used an esp32 that I programmed so I could set the target temperature over bluetooth. Then I connected a 36v 15a mosfet to that so I...

I used the MLX90614, only issue I had with it is when some herb went into the lens blocking it. The dabrite devices have some kind of...

I've done it using an IR sensor and switching on/off the zvs based on that. Worked pretty well until I started trying other coils and...