Recent content by enjiatt

@JCat Did this end up fitting for you? Im looking for a Bubbler that is in stock

Ill get a better Video Next week @cybrguy you were correct about the 19mm adapters, They seem to work fine. I found that the issue is when I have a rimmed basket in the stem it adds a couple MM to the bottom, which makes it difficult to completely seal. Fortunately without the seal...

Not too bad so far The non standardized glass is a little frustrating. DDave stems, my ebay stems, nothing :-( . Oh well I have a short stem and a long stem. I personally don't see myself ever using the short stem (gets too hot). I used some rimmed baskets with the long stem and got...

I ordered Wednesday night 11/28, Got tracking 11/29 , tracking says it should be here today. That was much faster than I expected. :clap::clap:

Just ordered my Splinter Z. Looks like there is some stock still

My favorite builds were with 18 gauge wire but its difficult to find a mod that can screw the wire down far enough. Im currently still using my 3.6 coil in the kayfun mod with glass. The resistance is still 3.6!!! Still seems to work just fine. I have to admit I dont use TC very often. I...

Patiently waiting for the Z to come back in stock. Does anyone know who will be the first to have them in stock once ready?

Well I'm back now and I see the mod world for vaps has brown quite a bit. I was doing a lot of diy post on the Bulli thread. My main concern was with having to replace the coils more often than I wanted to. It seems that the splinter may be the key. Quick question (trying to decide or the...

Im moving in with my GF and I'm going to have to get rid of all of my toys :-( If someone shoots me a decent offer I can bundle everything. Located in the DE, NJ, MD area. PayPal only or local pick up. Ship priority USPS. E-nano with 14mm gong and 18mm gong $120 shipped (sold) (shipped)...

hey @KeroZen i learned with the lower gauge wire you need to raise your wattage or the chip will think its taking too long to get to temp and kick you out. (im not sure if thats actually why, but I know with all of my low gauge builds I have to raise the wattage)

SOrry I always over saturate the forum with videos. First video is the best heat pattern i get with glass so far. i cant get the outer edges of the bowl not matter what I try. The taste with the glass is really nice but the big ELB still cooks more even. The second video shows how well the...

@Dan Morrison Here is that video THis setup has the same design coil but it is just a little small overall. .387 ohms It looks like It still retains heat for about 5 seconds.

@Dan Morrison Here you go. The spike in the beginning is the preheat for the coil to heat up quickly. Ill do a video tomorrow of me with vapor production stoppage.

This video is two different vapes with wide open airflow. The first video almost ghosts the entire bowl in that single hit. THe second vape is the same idea but with the mini elb instead. Just wanted to show different ways to get an even vaped bowl. These methods are with distance. and the...

have any of you tried modifying the airflow so that it is more open. This would help some with the hotspot issue. But you will need to turn up the temperature.