Doesn't help they're in the awkward spot of being sponsored by Dynavap... They had a mixup where they weren't sure if they should do their DV ads or jump into reviewing the Anvil. These boys are entertaining but I feel they MAY be influenced by their sponsors.
can you let the underdog preheat the stem prior to drawing? Maybe leave it on there for 15 or 20 sec and then draw to see if you can get some conduction heat going?
Unfortunately I believe this is a limitation of the glass stems. I've noticed the DV tips get some conduction heat from the heater when you let it sit on there for 10-15 sec prior to inhaling. This is preferred and doesn't require stirring. A big plus in moving to the woodscents from my e-nano!
Couldn't wait any longer for the lite kits to come back in stock... scooped a walnut kit off puffitup. Just gotta say that the full complete extraction plus the extra conduction you get with the TI tip is absolutely golden! Defeats the nano even though you can pack more into the e-nano... this...
Hey doc! So I've weighed out every pressing with 1g as specified. I am heating for 1:30 to 1:45 and I have tried 2:00 and also 1:15 but not more than once. I have the one g slug.
The whole process is as follows - break up herb into chunks that fit inside the hole, after two or three pieces I...
Hello rosin pressers! As expected I had issues pressing last night. First press - not enough heat. Second press - a bit better. 3rd - I even got a small drip. My concern is I'm not getting a solid chip. I have to pretty much pick apart the leftovers to remove it. Only some pieces are of chip...