Recent content by clive_bob

I'm a little confused. Are they round or do they have a small cup? Are they more difficult to empty and clean?

I was under the impression that it is not a good idea to remove the bottom so I have loosened the screw a few turns and lightly twist the case to burnish the points. I assume that you are removing the bottom to use an eraser. Does that cause any problems? Thanks.

Thanks! The long tubes are out of stock but I ordered a short one so as an emergency backup.

I can't seem to get to the website. I get a message, "website has expired." Where do I go for one of these?

Thanks! I was just looking for the site. Could you give it to me, please?

Is there anywhere to buy the TM glass stems besides Finland? I love my glass chair mat but I've dropped and busted two tubes on it so far.

Good advice. It's hard to imagine how the button could have been hit in a rapid enough succession to turn it on. It most likely was on for the entire trip.

I read a thread a while back that said you don't want the screw to come loose. I've been turning about 3 full turns.

How many ccw turns can I make when loosening the base before the screw comes out?

Sometimes a slight movement of my finger on the button restarts my TM

Did he make any improvements to the button?

The power loss happens so gradually that I didn't notice even though I have had to perform the process a couple of times previously. Now I will keep my Torx wrench nearby and pay closer attention. Immediate improvement of vapor!

I couldn't sit thru it either. Did he say how much they will sell for?

Thanks! Bazinga! Merry Christmas!

You won't believe this...I just unexpectedly received a brand new TM and a couple more stems that I did not order. Like many others, I was having a challenge getting service. I sent a couple of emails and got my original TM back in about 6 weeks along with several stems and a couple of dosing...