Got my Crafty + from Namaste vapes Must have been the best Black Friday deal on the net £143! Better air flow and 5-6 bowls per charge so far. Loving the improvements
A few more thoughts. I’m loving the new form factor. I like to hold it back to front and tilt it back. The new heaters great...
Just reporting back about my Dabstation controller re-wire it worked a treat! Thanks @JCat.
I got a 30mm Axil coil and 30mm banger. I couldn't be happier my enail has sat dormant for two years. It's great to use your favourite Quartz Bangers and caps. It's like a true dabbing experience...
Thanks for the help guys. Getting a 30mm axial coil and 30mm opaque banger from a friend who’s getting a shipment from 710 coils to the U.K. can’t wait I’m also going to get a SIC insert for 30mm bangers from Fadespace when available. I will post back when it’s all up and running. Ultimate set...
@710 coils some sic inserts would bring you inline with high end electronic nails. Great performance and they don’t chaz, They are pricey though over $100 for 30mm .
@JCat I rewired my PID. I should have noticed the pins are numberd on the coil I got them backwards!
So I just rewired the...
Thanks @JCat for the help and @710Coils for the kind offer to send a controller. To be fair it looks nicer than mine! I will open her up tomorrow for a look. Are you planning on doing sic inserts for 25/30mm bangers at some point?cheers
So @JCat this is my coil
Pin 1-2 was 498 ohms 3-4 no reading as 3 is ground pin 4-5 was 5 ohms. So
Pin 1 is AC load
Pin 2 is AC Neutral
Pin 3 is ground
Pin 4 is TC +
Pin 5 is TC -
So I will need to rewrite the PID making Pin 3 TC+
Pin 4 TC-
Pin 5 ground
So swapping...
@JCat thanks for the help . I have a multi meter and soldering iron.I don’t do much soldering! What’s the process just using meter with thin probes to check which pins Voltage comes from? Thanks in advance for the lesson.
Hi all I love the look of all the 710 coils products! I’m from the UK I started out dabbing from a Ti/quartz hybrid with a flat coil and cheap P.I.D ( the set up still cost £200 a Dabbie Dabstation, as there are not many choices for 240V ?) I moved on to Dab rigs and torch and quartz. These...
Cheers bro @anasrzi Thanks for your thoughts. I think @psychonaut thought it shouldn’t leak on connection? Only when taking off? Hopefully I will get a permanent Posistion to set up but not For awhile so I will check if I have another fitting with the supplied bits? Is it just a matter of...
@anasrzi you said your pump fitted perfectly?And you have the same as me (I think, see photo) Did you use the fitting the pump came with or the dabpress fitting? I need to check my bag of bits haven’t opened it yet.Mine worked fine but leaked when I pushed in the coupler? Resistance on the...