Recent content by BubbleDrop

While I do have a couple of 30Q and HG2 cells, I haven't tried those with the Toad. But I noticed that my Molicel P28A cells cannot fit, I can only use my P26A (luckily enough, I have quite a few of those).

I think he answered already. Have you checked his post at page 258 ?

Here is how the warm up looks like (double click to Cruise) : Anything seems wrong ? I'm not on Discord but I guess I'll have to get there and ask Ralph what he thinks about it.

Yes, tubo is installed (I also have a TETRAx using another P80/tubo), with the recommended parameters from Lamart already set : 0.200 locked, TCR 185. It is fine, but I guess I shouldn't get those results at low temps. :huh:

It could be some kind of calibration, but even at 175°C/347°F in session mode, the AVB is completely dark whereas it is light brown with my other vaporizers. Maybe I can try to lower the temp settings ? :hmm:

Still trying to figure out the best settings with the P80. Anyone using this mod as well ? As the mouthpiece is quite short and heats a lot, I have added a fat mouthpiece for Vapcap. Should work fine (haven't tried yet). :)

Just check their websites and you'll get their contact information.

Ok ! I also didn't notice any issue. This was a bit akward though. I tried to change the base resistance value and set it to 0.200, 0.210 and then to 0.220 but couldn't get nice results unfortunately. It worked better with the P80 using the settings provided by Lamart (0.200 locked, TCR 185)...

I was lucky enough to score a BAKx from the last drop and received it a few days ago. This is such a great vaporizer, quite tiny and super light too. I don't have a DNA mod so I configured a Sinuous P80 mod with Lamart indications and it worked quite well. One issue is that even at low temps...

How many Nomads is there per batch ? I might be in batch 62. :(

Thanks a lot ! Just ordered one. :)

Where can we find this WPA ? I'm using the OCWW Inception stem with my TA3 but I'd like to get a proper WPA like the one you're using.

I think Dan recommended this at some point (using the low heater) : 7s preheat then 10s inhale for the first draw. And then, you can do 6s preheat then 10s inhale. Repeat until you see no more vapor. :lol: This has worked great for me.

Maybe you could use this topic. :) https://fuckcombustion.com/threads/madheaters-shipping-thread.54686/

Did you ask Dan how long it should take ? For me it was around 6 months, I think.