Does anyone else have issues with a sticky mouthpiece? The resin buildup has gotten pretty strong. How do you handle this, I don't think soaking the plastic piece in Iso is a good idea
Welp, looks like my Gen 1 T Vape has finally died. Everytime I start the oven it cuts off like there is a bad connection at the rubber seal. Ive made sure the area is clean and screwed on tightly, but still no luck.
It was fun while it lasted.
I wondered the same thing before i bought mine, found no info on the unit besides this thread. I dont think the vape has been out for a full year yet. High times did a little bit on it here but it didn't score very well...
I carry my TVape in a cheap cylindrical toothbrush case when transporting, never have issues with the mouthpiece falling off.
Regarding the deadzone, It was mentioned earlier to add a bit of AVB at the bottom of a new bowl. I get an even dark almond vape every time.
My Charging plug went out after a few uses. Tried using my HTC charger and that only gave me a blinking light charge, no matter what USB cord I use. Never kept it on the charger more than a few minutes out of fear of damaging the unit, so I only use my computer to charge. Hopefully mine...
I noticed the dead spot at the bottom, eventually I will try to add a piece of cotton as mentioned in earlier posts. When I think my pack is almost done, I always dump contents, mix, and re pack to get an even vape
Recently purchased a TVape, definitely enjoying it. Sadly my power supply has died and when I try to plug the USB into my phone's AC adapter, the red charging indicator light blinks. The input and output of both chargers is the same and the only way I can get a good charge is through my...