Recent content by birdbraineater

The all glass Vapor Genie Sherlock, coupled with the heater from the ELEV8R and a Blaster 8000 torch is my daily go to.

ELEV8R and a Blaster 8000 torch

So far, the only difference I see/find/feel between the VapCap OG and the VapCap Woodie is that the VapCap OG will most likely break if it gets dropped. Other than breakability, the price, and of course the aesthetics, they work the same, feel the same and vape the same.

I find that the Vaponic vape holds heat much more evenly (and better heat retention) than the VapCap's heat retention allowing for more, smoother, and tastier hits.

Fine particles pass through the VapCaps inner screen. It's been advised to use a 'nugget ' instead of ground.

You can still get the original base model VapCap for $30.00.

Thanks dude

It's cool that personal adjustments are available. it's too bad the vid is too blurry to see whats going on tho. If I owned the model in the vid it would most likely make more sense.

very blurry but thanks.

how?

For those of you that like bubblers with your vapor, the www.percotop.net is interesting in that the 'rubber tip' mouthpiece of the VapCap fits like a glove into the bottom of this rig. The Blue (the panama)and the Yellow (the Fedora) percotop are drip-less if you should lay them down.

I'm not sure how that could be measured.

I only throw in a small nugget. About the size of a wooden match head. I heat up to the click, have a couple puffs, let the cap cool off and toss out the AVB. I think a second heat cycle would burn the bud. I'm sure as hell not going to eat the AVB.

It should fit quite nice into a 14mm female joint.

There's a hole in the outer glass of the VapCap and when covered by a finger, it offers resistance to the draw making it extremely similar to a joint. I'm sure you'll like it.