Recent content by all-Glass-Nerd

Hi! I was referring to the oven tube. Ribbon sounds like a great way to get good heat transfer. I just applied a very thin watered down coat to a new oven tube prototype for my design, hoping it wont crack this time, but might try out some ribbon next! I guess an advantage of a dry friction fit...

A metal tube that is split in two halves, and then spring loaded, and grasps (like a 'clip') on to the glass tube, could be a way to inductively heat it and allow some expansion of the glass so it doesn't crack

Any updates? It's like an electric version of the Vaponic vape design, seen a good DIY thread on cloning that one, but not using electric heating and temp control. Great craftsmanship and engineering! :clap::clap: I working on my own vape that is similar to this in how it works fundamentally...