The Magic-Flight Box

Discussion in 'Portable Vaporizers' started by magicflight, May 16, 2009.

  1. axakal Active Member

    Message Count:
    120
    Location:
    Köllifornia
    i "upraded" my box with it, but took it out shortly after that. it required too much extra pushing. especially using it with the old wpa was very unpractical.

    smatter likes this.
  2. smatter Member

    Message Count:
    36
    I'm going to pull it out tonight and see how I like it.
  3. Buildozer Well-Known Member

    Message Count:
    463
    Location:
    S. California
    i have never not used the push back ring in my LB's.. mostly because i like pulsing the battery and it helps for that.. only time i haven't used it was on my friends first gen LB that didn't come w/ it. i don't need it but iv'e become used to it so i leave it..
  4. skippy Active Member

    Message Count:
    137
    Location:
    Australia.
    I've never used my box without it, but I have thought about it. I wondered if you got a better/cleaner connection by not using it? But I was also concerned if I stopped using it I would be more likly to combust given I'm not used to having to pull the battery back out, or though my current box is not as tight as my last box was and the battery would probably just slide back easily.
  5. Broseidon New Member

    Message Count:
    3
    What voltage are your guys' batteries when they're freshly charged? My batteries have been sitting around for a few months with no use and when I tried to charge them in a regular charger they would hardly heat up my mflb. I bought a MH-C9000 and used the break in feature on them and they were reading at about 1.3 volts after the process which I believe is fully charged? The thing that confuses me is they still HARDLY light up the bulb in the mflb and I get little heat. I can't tell if all my batteries went bad from sitting or my mflb needs to be replaced.

    Any help would be appreciated.
  6. BigDaddyVapor @BigDogJunction

    Message Count:
    3,001
    Closer to 1.4 +/-
  7. wild1willie New Member

    Message Count:
    9
    i have had my mflb about 2 weeks the day i brought her home i bathed her in hemp seed oil hoping to induce some very fertile head trips .
    as the relationship has progressed i have found she has some sharp edges near her peek-a-boo hole. I have used some very fine sand paper and gentle massaged her while we vape together were ever we are so she has become more molded to fit in my hand i think shes almost as nice as my new woman. she is most certainly less noisey oh shit i broke something please my appologies idont know bye
    pakalolo, axakal, smatter and 2 others like this.
  8. stuey Member

    Message Count:
    293
    I think you need to use the refresh mode rather than the breakin mode.

    If that doesn't improve things then get a new set of batteries, obviously if a new set doesn't improve things then its the LB and you need to then get a replacement.

    As there isn't physically much that can go wrong with the LB its far more likely to be the batteries than the LB.

    I have a La Cross charger and refreshing the batteries every few months shows a noticeable improvement.
    smatter likes this.
  9. pakalolo RoboMod v3.07 (stable)

    Message Count:
    3,536
    Location:
    Other side of your screen
    It would certainly be shorter. The break-in mode is actually multiple cycles of the refresh mode. Sometimes a break-in will revive your batteries so it's not unreasonable to try it. If these are the original Imedions, then sitting for a few months shouldn't kill them and a break-in should help them. On the other hand, I think it's more likely that the batteries are failing, so I'd try new batteries.
    Vicki likes this.
  10. vii Member

    Message Count:
    23
    Location:
    canada
    what the best way to clean the wooden stem?i think mine needs to be clean.
  11. OF Well-Known Member

    Message Count:
    7,873
    Location:
    Left Coast
    Pipe cleaners?

    OF
    BigDaddyVapor likes this.
  12. Vicki Herbal Alchemist

    Message Count:
    2,743
    Location:
    Milky Way Galaxy
    That's what I use to clean my wooden stems.
  13. vii Member

    Message Count:
    23
    Location:
    canada
    Thanks!!
    The pipe cleaners work perfect !i finally got to use pipe cleaners for there intented purpose:)
    OF, smatter and sydnee like this.
  14. OF Well-Known Member

    Message Count:
    7,873
    Location:
    Left Coast
    You're welcome.

    Pipe cleaners are actually excellent cleaners of pipes, unlike duct tape which is a lousy choice to tape up ducts it turns out......

    Best wishes.

    OF
  15. octo What does that mean?

    Message Count:
    18
    So is it completely safe to clean the screen with rubbing alcohol and a q-tip? I try using the brush as much as possible but it's not getting everything out. My screen is getting pretty dirty and it's starting to affect the performance of the box.
  16. OF Well-Known Member

    Message Count:
    7,873
    Location:
    Left Coast
    NO! It is not "completely safe". It needs to be done very carefully and with an absolute minimum of alcohol. That screen is frail and even a tiny bit of ISO will wreck the wood.

    You should do a minute or so 'dry burn' to evaporate all the alcohol off afterwards.

    In general, if your box is fouling it's because your bud isn't cured well enough. Dry, fine ground bud, shaken between hits really doesn't foul.

    OF
    octo and BigDaddyVapor like this.
  17. kushcabbage vapor nerd

    Message Count:
    876
    Location:
    cloud 9
    So.. :) I just ordered a full kit on a whim. Cherry Flower of life etched MFLB with the PA, cherry stem, cherry waterpipe adaper, and all three herb blends. Anyone have any experience with their herb blend? Very curious and very excited to have a magic flight again!!
    Vicki, nopartofme, smatter and 2 others like this.
  18. axakal Active Member

    Message Count:
    120
    Location:
    Köllifornia
    i ordered one of the blends along with the pa, but it got stuck at the customs. as soon as i recieve it, i will post my feedback.

  19. Quetzalcoatl drop beats and bhombs

    Message Count:
    1,735
    Location:
    SDCA, 3rd Planet
    You'll love it. Mine sits at my desk permanently. If it weren't for the kick-ass batteries, I'd use it more... but I do find it incredibly useful for certain situations such as more specific cannabinoid ranges, as well as when my batteries are charging. I'm happy knowing it's there and working as soon as I push the button.
    kushcabbage likes this.
  20. BigDaddyVapor @BigDogJunction

    Message Count:
    3,001
    Funny... I just found the little packet, Linus sends with the VB. Its the same stuff, btw. At least, if I remember correctly... but I'm pretty sure its the same herbal proprietary blend.
    kushcabbage likes this.
  21. justcametomind Active Member

    Message Count:
    203
    Yes, reading of you buying that blend I went to the MF online shop and they state it's made by the good folks at Vaporbrothers :)
  22. kushcabbage vapor nerd

    Message Count:
    876
    Location:
    cloud 9
    wow I just got the most heartfelt warming personal email, from magic flight and it's just to confirm my order! Very impressed already!
    Quetzalcoatl, nopartofme and Vicki like this.
  23. Vicki Herbal Alchemist

    Message Count:
    2,743
    Location:
    Milky Way Galaxy
    I decided I am going to order the cherry LB in a couple weeks. Don't forget to let us know how you like it! :)
  24. vapirtoo Active Member

    Message Count:
    467
    Ive been drinking and vaping the herbal teas from the Vapo bros. for two months.
    I like the balancing bleus and the sweetly calming combos. They make my LB
    smell and taste wonderful.
    axakal, Quetzalcoatl and kushcabbage like this.
  25. Dr. Plutonious Member

    Message Count:
    85
    So I'm borrowing my friend MFLB and I still cannot get a visible hit off of it. I believe everything is working properly. There is a little red light I can see in the unit when I push the battery in all the way. I just don't get any visible hits. The weed hasn't browned at all either.

    I'm charging another battery as I post this incase the current battery I have is too weak. Does anyone have some tips?

Support FC, visit our trusted friends and sponsors