Bouldorado
Well-Known Member
Had access to some nice power tools for a while, so I decided to make a slide holder.
I took an old piece of maple flooring and planed down the edges with a table saw. Following that, I cut it in half and then drilled holes for the joints. After the holes were drilled (two 14mm, two 19 mm) I glued the two pieces together with some gorilla glue. Turns out the 19mm holes were slightly too small, so I widened them with a cutting bit on a dremel tool. Sanded the whole thing down with 400 grit paper and polished with beeswax/olive oil.
I took an old piece of maple flooring and planed down the edges with a table saw. Following that, I cut it in half and then drilled holes for the joints. After the holes were drilled (two 14mm, two 19 mm) I glued the two pieces together with some gorilla glue. Turns out the 19mm holes were slightly too small, so I widened them with a cutting bit on a dremel tool. Sanded the whole thing down with 400 grit paper and polished with beeswax/olive oil.