1. What does SSTB mean? See our glossary of acronyms.

Help Me Choose a E-Liquid/Conc. Vaporizer

Discussion in 'ABV' started by cawshook, Mar 16, 2014.

Thread Status:
Not open for further replies.
  1. cawshook

    cawshook Solod out.

    Messages:
    635
    I stopped smoking like a little over a week ago using e-cigs, and now i cant go without them. I'd like to continue using e-cigs for now, whilst lowering the nicotine (im at 12mg, and going to 6 mg very soon), until i no longer crave nictone. I just ordered an Aspire Nautilus tank. This tank works for the cheap E-cigs. They come with a 510 threading i believe. I will be more sure when it gets here.

    I want ONE vaporizer that can let me use my Nautilus tank AND use my homemade QWISO shatter (not the best quality/pureness so id like something that can handle that).

    Most of the time for oil. I go for the small puffs, hold it in for 5 secs, but every once in a while I like to get some big ass hits. So i just bought a 3.7V Ti Kiss Cart to use with the G-Pen (i hope it works).

    I need help deciding what to buy. I want one device to power the Nautilus tank, Kiss Cart, and those extract cartidges that i can fill and use for small hits. I NEED it to be portable, and either it has a good battery that can last a lot, or I can carry another battery.
    1) Which one of the Omicron lite, Persie, O-PHOS, Omicron 2.5 should I get?
    2) Which cartidges should I get?
    3) Would these cartidges work with other Variable Voltage E-cigs? Like the Innokins and such?

    Im looking at Omicron v2.5+ 2.4 ohms right now.

    Note: Im an amateur when it comes to oil, and I do not have access to anything better than what I make.
     
    Last edited: Mar 16, 2014
  2. GetToTheChoppa

    GetToTheChoppa Active Member

    Messages:
    120
    Hi there!!! Im still a beginner but can try to help a little.

    Im not familiar with the G-pen but im guessing it has the 510 threads? That will require a 510 to 601 threaded adapter because the 3.7v Kiss cart uses 601 threads.

    1. How much are you looking to spend? The O-phos is a great deal at $50. The Percei is a monster and can run at 7.4v and will provide the big ass hits you so desire. The omicron im not too familiar with but falls in between i think.

    2. For your homemade shatter? Im not sure amigo, but i think the KISS cart will work. If the purity is low it might reduce the lifespan of the cart.

    3. Most this stuff runs off 3.7v batteries. Are you saying you have a variable voltage battery and curious if it will power the carts youre putting the shatter into? It should work with proper adapters to match the battery to the cart. If you buy a W9 UpTech unit like the O-phos, omicron, or Percei, you would need a 601 to 510 adapter if your e-cig carts use the 510 threading.

    Congrats on stopping smoking!! Way to go.
     
    cawshook likes this.
  3. max

    max Bingo Coordinator Staff Member

    Messages:
    9,187
    If you're looking for one vape to do both nic juice and mj concentrates, I'd quit looking. The temps needed are very different and unless you want to clean before switching, your mj sessions will taste bad.
     
    VapeNStone likes this.
  4. VapeNStone

    VapeNStone Mark

    Messages:
    2,773
    ^^^this. Don't most of the tops fit the 510 threading? Why not just switch between the two tops? I myself use the VapeApe for my concentrates but it is just for waxes and shatters etc...
     
  5. Caligula

    Caligula Maximus

    Messages:
    6,872
    Location:
    SB420 Land!
    Ill elaborate when I get more time.

    For now, ill say that the G Pen sucks. They also use 601 threading on their products like W9.
     
  6. cawshook

    cawshook Solod out.

    Messages:
    635
    I know the G-pen sucks, the battery seems to be ok, but the cartridge i dont like at all. This is why i made this thread. I want to buy a w9 tech product. Please do elaborate further when you have the time, and thanks.

    Also just to clarify again, Im looking for one device to power the Nautilus E-juice tank (which works on even the cheap e-cigs), the 3.7V Ti KISS cart so i can get big hits when i want, and the extract cartridges from w9 tech. Im not looking to use the same device with the same attachments for E-juice and conc. they will be separate attachments.

    Thank you to everyone that replied to this thread, i appreciate the help.
     
  7. GetToTheChoppa

    GetToTheChoppa Active Member

    Messages:
    120
    Ah....sounds like all you need is a 601 to 510 adapter so your E-juice tank can fit on whatever size W9 battery you buy.

    Or get a variable voltage ego 510 battery and a 510 to 601 adapter to power your 3.7v Ti Kiss carts and extract cart. I prefer that way because you can dial in your voltage and heat for different needs.
     
    cawshook likes this.
  8. cawshook

    cawshook Solod out.

    Messages:
    635
    Thanks for the help guys, mods can close this.
     
Thread Status:
Not open for further replies.

Support FC, visit our trusted friends and sponsors