First ever attempt at BHO-How does my wax look?

W

waaldron

Active Member
I bought my first blasting tube yesterday. I fit about 8 grams in a quad tube without forcing it or feeling like I was over packing. I blasted with 14x filtered butane directly into a pyrex dish floating in some almost boiling water. Let it react and bubble on its own for a bit while switching the bath water a few times.


I then scrapped the product up and put it on a silicone pad. http://imgur.com/YakwYhr


It stayed like that until I eventually turned it into by cooking it in my toaster oven at about 130. http://imgur.com/YHGVPQr

Edit: I didn't decarb my weed is one thing I did that I am going to fix and I think I set the temperature too high when I oven purged. Also I'm sure the toaster oven isn't as accurate as it says.
 
Last edited:
waaldron,
walrus

walrus

Well-Known Member
I would purge that a lot more before dabbing it if I were you. I'm assuming you don't have a vac setup but I'd at least spread it thin on parchment or directly on Pyrex and leave it over a low heat source for a couple days. Won't get a perfect purge without vacuum but you should see a marked improvement over what you have currently.
 
walrus,
amberevil

amberevil

Well-Known Member
Yea yea. Best value vacs all the way. Low low prices and peace of mind. I would recommend the round Pyrex chamber kit. The silicone gasket are better than the neoprene ones. Also its nice to just blast in that dish and then finish the whole purge without even tuching the concentrate
 
amberevil,
  • Like
Reactions: DieHard
You must log in or register to reply here.
Top Bottom