E-Nail Settings/Programming
- Thread starter JCat
- Start date
ChadHammer
New Member
Okay. I also accidentally held down the set button on my high5vape enail and flipped through the settings before shutting it off.
It's the led#2 dual enail. The mypin Ta4 controller. So the one side seems to heat up very slowly, and the other side works perfectly fine I'm just too scared to go into the setting of the good side to match them
I know this is off-topic but ya'll seemed knowledgeable on the subject. Any advice on how to fix the slow-heating side?
It's the led#2 dual enail. The mypin Ta4 controller. So the one side seems to heat up very slowly, and the other side works perfectly fine I'm just too scared to go into the setting of the good side to match them
I know this is off-topic but ya'll seemed knowledgeable on the subject. Any advice on how to fix the slow-heating side?
SavageCore
Well-Known Member
In case anyone ends up here looking how to access "CorF" on a 710 Coils (Disorderly Conduction x Peli Saver) unit you have to enter 0036 on the SET menu, not 0089 as I'm used to!
GratefulDread
Well-Known Member
Does anyone know if it's possible to calibrate Menovo PIDs? My temps are way off.
