Search results

Thanks. Z9.. anyone else with an idea? (besides "delete"?.. lol ) I might try a phone call into Vapir.

I'm sad today for last night, in a pinch, I used a charger cord from one of my old computers. When heeating up, The NO2 unit started blinking a faded then brightened temperature screen, meanwhile it showed a quick increasing temperature of 3-4 degrees at a time, then brief pause during the fades...

I haven't been around for a while.. going on two years of daily use with this NO 2. Holding up well.

Been about a year. Unit still runing like a champ. Used at least once a day during this time. Vaping may have saved my life.

I have a couple updates to throw in. One may be connected to the "plasticky taste issue." The other has a question connected to it. I'll try to be brief about both since some think I have been too prolific in my past comments. 1. As some have done, I removed my screen from the bottom a while...

It's prob not something anyone else has happen ! (?), but I can run out of fresh herbs from time to time. I started saving the Iolite AVB, and at the time I swapped out the NO2 with my Iolite, it was one of those moments in time where all I had was AVB. So you use what you have. Plus I COULDN'T...

I had a couple incidents that the unit was tested. 1. dropped it out of an unzipped pocket somehow, and it was exposed to a light rain in the woods for about 30 minutes. Fortunately I was able retrace my steps and found it on the ground. A bit wet on its backside (non-electronic side). Wiped it...

two months+ into ownership.. Daily use. Running like a champ still. Thank you God! I did go back to using the tube for drawing. I found it a little easier to draw through and easier to get deeper hits. I also quit opening up the unit to remove material from sitting in the top of the chamber...

I am almost CERTAIN that much of the "electronic" (or whatever each we Vapir No2 noob) talked about smelling, is related to the screens in their brand new state.. I took my bottom screen out and haven't put it back in, and held the top screen over a lighter to burn off whatever is/was on it...

Sorry, I should have read my previous post and seen how it was too brief to impart what i was trying to say. What I was getting at, was that I am pretty sure the screen itself was getting hot enough to put out some sort of flavor of its own.. and seemed to put out its own cloud/smoke. In fact...

Added info, Been using the unit without any screen in the bottom. I think it seemed to add a flavor by getting so hot. I think I notice a difference with it not being there. Will know more if this is true, when compared to what I experienced with screen in. So far, no hiccup in the...

Everything still working like a champ. However, I am going to wade into this issue of what we are tasting that may be causing you alarm. I have put two and two together on this, and maybe come up with four. The screen in the bowl of my unit has defined marks where the bowl is heating it to...

The only experience I can add to this part of the thread about "plastic" taste, is that in my limited experience vaping.. (iolite and now No2) I have no alternative standpoint (ie. glass on glass) to compare them to. So perhaps it is a blessing that I have nothing to discern between, and which...

I dropped the unit accidentally onto pavement from about 6 inches, and was relieved to see it still worked! The screen question is in regards to not damaging the screen. it fits so snug, as I mentioned above that I found no way to get it out but to slide the spoon between the screen and the...

battery life was from 10 am to 8pm used about 7 times in that span. Recharge for me, has been on the go.. but the above full charge usage was on a multi hour (overnight) charge. Since then, I just plug it into the car or an outlet to get up to hot in 30 seconds.. then run it on the battery for...

True so far... nothing negative to report. Keep in mind, I am looking for losing draw or losing dense vape for any reason (and I dont think that is going to happen), erratic start up, or something just not working Cleaned the unit for first time to remove gooey substance from top with...

Please remember, MY long winded (glowing) report/pitch is only "glowing" about No2's successes in amounts that are equal to the frustrations which the Iolite caused me. Since the frustration-factor with Iolite was so great (for me), I am enamored with this vapir No2 product which so far, lives...

Rudy Rudiger: Screen report... I have used this now for a few weeks 4-5 times a day. I don't think the screen needs any cleaning yet. There is some need to do a cleaning to the top of the unit though, because I am starting to get a gurgle of "vapor resin" when drawing hot (Not sure what you call...

Yes it will fit into a large soft drink cup, One of the large plastic ones like you get with a superzize drink from McDonalds.. rather than the (less large) paper type. I'll try to get a picture of it in here. This also adds one more +, imo, to the No2 over Iolite. When going in such (cup)...

Andrew the only thing I can think of is that your drawing fast and furiously? If so, welcome to the club, I certainly inhaled on my first sessions way to fast. After a while, the balance seems to be found which logic would tell you allows the herb to marinate in the heat and be drawn off...