Search results

I was looking at the Mobius matrix, anyone like that downstem?

I have a typical beaker bong and need a 5.5" downstem for use with concentrate. I'm thinking I want a 6 slit gridded downstem because holes won't get as clogged as slits and I hear it pulls betters with gridded. I was looking at...

I'd be interested in seeing more of this build, what stand are you using?

Put a super small dish between clamp points on VV mesh and then use mesh screen in a upside down W pattern with only the middle point of the W being sharp and the others rounded so only the sharp area heats up. Then, put this sharp crease in the cup and load up the cup. Cheap, easy, and...

Have either of you two using the ceramic donut and cup use a liquid pad like this http://fuckcombustion.com/threads/vaporgenie-liquid-pad.19141/ ???? Was curious if you found the right size, put it on top of the donut, maybe wrap mesh around the entire thing to prevent from moving, and load...

My question would be how much are each of the heater elements quartz vs ceramic donut? And how long does each last with proper maintenance? Is that top air flow really that much better in the QQ? I like the idea of a bowl setup for sneaky hits and another bowl for chilling and sharing. My...

Assuming I'm being clear enough that is just using words and not drawing something out.

Accept, the problem I think with your prior experiments was wrapping the coil up the sides and not using a dedicated stove top coil design solely to concentrate the heat. Thus, if you use the mesh I'm hoping the heat will only minimally transfer to the mesh and stay with the coil. With this...

Yep, I was assuming the mesh would be oxidized. The purpose of the mesh is to allow the wire to concentrate the heat on the bottom and for the mesh to hold the cup in place and prevent spillage from tilting. Also, I believe you can vape was at 400 to 500 degrees F. Not sure why'd you'd have...

Good to know Accept. My idea for the sourcevape cups is this, make a stove top coil that the cup will sit on. Make the coil large enough to extend beyond the cup and allow you to wrap some mesh around the cup and between the wires of the stove top coil. Utilize long enough mesh when doing so...

Accept, I'm back at it again. Great to see you and 2clicker keep this thread going. I wanted to ask first what your thoughts were on utilizing those SourceVape cups were in terms of effectiveness? I like the idea of on the go hitting without having to refill for at least 5-8 hits. If you...

Here is the video with the cup coil I was referring to and that the glass or titanium insert nail could be put into: Yes, the Mesh RDA would give you a ton more room than other post rda's and I believe this extra space is absolutely needed to make this work. I don't think the vertical...

We are on the same thinking. I'm thinking about grabbing that 24mm diameter Vandy Vape Mesh RDA and combining it with this https://www.sourcevapes.com/collect...-dabber-carb-cap-portable-enail-erig-vape-pen. I don't think or even know if that bubbler will even fit the vandy vape though, but the...

messed this post up, see next one.

Yea, that would work good. Make the cup coil thing and then put one of those little inserts in. Do you know where to buy the inserts separate? I can only find ones that are threaded and not ones with the flat bottom.

Alternatively, I was also thinking one could just grab a titanium nail like below and just wrap a coil around the bottom part to achieve the same cup effect. https://dabadovaporizers.com/collections/nails/products/bolt-titanium-xl-nail

Just found this thread. I see people are doing some complex threading of coils, but I wanted something super simple using a single coil and just a simple wrapped coil. What I found was this guy in the video below creating a standard simple coil, turning it vertical, adding a mesh screen at the...