qwiso destroying attys

tony yayo

Well-Known Member
Actually it's qwet and I've had this happen some times with bho. Seems to be with the more unstable stuff usually too. Just leaves so much residue that after a day my atty is pretty much done for. It's pretty damn clear and I filtered this stuff through a 25 micron syringe filter too. Even tried to do some extra purging to harden it up thinking there was some alcohol left over but it's still the same. The buzz is definitely there I just don't understand what I'm doing wrong. May just use this with that ejmix I bought a while back and never used but I would love to know what to do to avoid killing my attys.
 
tony yayo,

tony yayo

Well-Known Member
Nothing, huh? I will add that I was originally using it in a cloud mini with an all ceramic bowl. Finally got an Orb in the mail the other day and it doesn't seem to have left much hard, black, crusty gunk. Probably cause the Orb fires a good deal hotter but it is definitely turning the rods black. Afraid to try it with the Terra atty.

I just can't figure out where my error is. I put so much effort into making my stuff nice and clean but it keeps killing my atomizers no matter what. Could I be using too much heat during evap and that's what's causing this?
 
tony yayo,
I use the ejmix with qwiso in a sub ohm attomoizer. 2 different ones actually. Before one tank ( 2-3ml) is finished, the coil clogs up. A couple dry hits prime the wick for a 4-5 good pulls, then needs to be re primed so to speak.
 
RollinCoal420,

tony yayo

Well-Known Member
I don't mean just dirty, I expect them to get dirty. This is bad and it's got something to do with my tech. I don't understand because I filter this stuff like 3 times, once with a 20 micron syringe filter, winterized, activated charcoal... I seem to do everything like I should I'm guessing I'm just using too much heat during evap?
 
tony yayo,
I can't really give solid advise about that, as I'm still a rookie at it, but I use a fan, no heat, to evap most of it, then transfer to a shot glass to evap the last little bit in a pot of hot water. Then it's already ready for the ejmix.

I don't do the charcoal step, but mine is ussually not the prettiest. I started using an attomoizer with a smoked and textured tank so alll u can c is that there is something liquid in there. After about 2 loads, I need to disassemble and clean with ISO. It also leaks like a sive. No matter which Atty. If it sits, it finds a way to leak. No matter the orientation.

My shit is pretty dirty also. There is a bit of info on this thread about this topic.

http://fuckcombustion.com/threads/m...quid-potent-effective-cheap-easy.6287/page-16
 
RollinCoal420,
Top Bottom