So which model did you get?With my dab master i can get thick vapour after it has been on and heated at around 3-4. I have only combusted when dabbing oils at 11 and being very wasted,you have to be quick and not let the product sit in the bowel to long.Bellow 11 i find no issues of combusting.
well yeah it's dry... I all most never run vapor through water
Whoa lol man that must be some fucking hot vapor!
Hey tell me, doing dabs like that is it a challenge not to have your dab drip back out of the heater, or do you just jack the heat right up - in which case this could be pretty bad for your airways out of sheer heat alone lol!
Still, would be undeniably tasty and those hits would pack a punch! Now this needs to be tried with a quartz dnail lol and i have just the setup for it!
Hello brucee10 ,have you received the new monkey controller yet? If so how are you finding the sub now?
I use the Moon tool that came with mine,the atomiser i have is the short stem one.I used the moon tool to push the screen down into the indentation for it.I found it easier to do when i have removed the bottom piece as its easier to manipulate from both ends..
That's good to hear. I'm glad that the moon tool is such a useful device.
no, I never got a moon tool... still lovin' my sub though
Same here. It is very elusive!
My moon tool was razor sharp on the edges! Happily went without using it very quickly!So the moon tool is the big flat stirrer thingy?
I honestly don't find it any more useful than any of my other assorted stirrers/Dabbers etc. but you guys def should've gotten one if you were told you would
It can be a bit rough as it is pressed out irc.Just to add mine is now dripping out sublimate,which is a nice bonus.At the moment i use a cheap Chinese glass reclaimer from kathy which has male ends.I am thinking of getting the proper sub reclaimer from pv. Has anybody used this with the Fc-ufo whip piece?I am asking as the Chinese one just fits across the top of the Fc-ufo glass.
