turdhole
vagabond
How, Damn you, How!
almost everything was 50% off from that seller
on another note, i need this in my life.
http://www.dhgate.com/product/glass-cup-oil-rig-smoking-water-pipes-14mm/232295232.html
How, Damn you, How!
No offense, but what you are showing in the picture is a king double bubbler I believe (much larger), not the regular double bubbler, and as far as being real, well I sold it here within 5 minutes in the classifieds.No offense, but are you sure it was a real Sovereignty? Because the tree percs look pretty sealed to me on the real thing:
Some vendors including Yingmin5 seal the bottom of the tree percs. (I believe we have confirmation of a sealed bottom on the GB-194)
The reason being that without sealing them, the percs will favor the open bottom over the side slits, causing the bottom to fire in a very chuggy method, providing less diffusion
It is cosmetic only, sealed or not.I asked about the open tree perc in the EVO thread and was informed the evolver hydratree has always been open. I haven't any experience with tree percs other than my 11 arm AC from China and it is open with two slits on each and the bottom does not fire before the slits because the water doesn't get pulled that low to cause it. I'm sure you can pull hard enough to get the open ends to fire but I don't see how an open ended hole will fire before the slit higher up in the water fires.
not necessarily cosmetic, i never put water in the second chamber of my D22 because of thisIt is cosmetic only, sealed or not.
Look at this BS the Kathy Egg being resold for $140....
http://iconosquare.com/p/945157663332301740_1476647621
...well apparently the rabbit hole goes deeper: https://instagram.com/glass_firedepartment/
#GlovesThrown and since you follow this thread apparently have some?
You're taking the spirit of this and turning a profit on the community /endrant.
Look at this BS the Kathy Egg being resold for $140....
http://iconosquare.com/p/945157663332301740_1476647621
#GlovesThrown
These sales couldn't have come at a worse time (for me), I've got a new card on the way and all this 1/2 off chi-glass would've been the perfect way to break it in.
I'm looking for a 18 male to 18 female drop down to fit my GB-187-1. Does anyone have the one SSS has? I don't know what to call that top joint where the perc is married to the top of the can, but the one I have is sunk down a little and I'm afraid the drop down won't work with it. Do you guys think I would have a problem?
http://www.dhgate.com/store/product/18-8-mm-male-to-18-8-mm-female-glass-drop/179241408.html
Meh, I'd pass unless the design speaks to you.Anyone care to critique this recycler? Is the return/bottom intake too close to the percs?
I've received dropdowns and adapters from this seller, all good and timely shipping... browsing his stuff to piggyback shipping
http://m.dhgate.com/product/product...s-bong-birdcage/214701656.html/214701656.html
I've been looking at the FC-187 V2 (link above) from Steven as my next purchase. But I just ran across a water test vid with it and was a bit underwhelmed. It didn't seem to have a lot of diffusion.
Is there any particular piece that is known for its diffusion? I don't mind a harder pull but would prefer a less chuggy draw. Maybe a D020-w2?
http://m.dhgate.com/product/d020-2-w-clear-glass-water-smoking-pipe-with/208893527.html#s1-20-1
I had the FC-187-V1. And learned about the importance of a well built matrix perc in order for it function properly. Simply put, my original V1 perc was made by a drunk person - the cuts were not straight, and varied in width which negatively affected it's performance
The FC-187v2 supposedly has a better matrix perc, but I don't know how much better.
I opted to purchase the GB-187-S from Yingmin5 instead. I LOVE IT! The glass is slightly thinner than the FC-187, but it's a much better piece in my experience - the matrix perc fires perfectly around the entire piece!
http://www.dhgate.com/product/hot-s...lass-smoking/229344799.html#s1-0-1|2993025544
This piece is currently sitting in front of me, and I've been enjoying it all morning. This is definitely one of my favorite glass pieces currently
thing that I don't like about Yingmin's is the attachment of the MP is a bit low on the can.