Arizer Solo

Slow Draw McGraw

Well-Known Member
Company Rep
Is the E-nano better than solo in comparison?



So do you have a EQ too? I recently bought one and I'm disappointed because how much material it uses compare to the solo. Yumm blueberry sour dream with solo? Damn bro you are living the dream!! LOL

Well e-nano is a desktop so hard to compare honestly. If you want a portable that can hit pretty close to a desktop for under $200 the Solo is your vape. You vape mostly at home and want huge rips....you know the rest.....

The tone to your earlier post just seemed like you wanted something that hit bigger than the Solo which is why I suggested a desktop. You have your minvap and mightys but not for under $200
 

LongIslandmom

Well-Known Member
Carol King: is the short mouthpiece a little harsh on throat because it's so close to the heat source. Even though I should always use some type of water filtration I find the straight solo MP very smooth. That's my late night go to peice.
 
LongIslandmom,
  • Like
Reactions: ctxgooner

Slow Draw McGraw

Well-Known Member
Company Rep
@LongIslandmom
Stay on first two temps and you should be fine.

Used my solo with the Air stem with plastic tip. Huge fkn rips. Its just like when I used the silicone e-cig tip mod on solo stems. Pretty similar. E-cig tip stays cooler then the plastic.
 
Last edited:
Slow Draw McGraw,

CarolKing

Singer of songs and a vapor connoisseur
Carol King: is the short mouthpiece a little harsh on throat because it's so close to the heat source. Even though I should always use some type of water filtration I find the straight solo MP very smooth. That's my late night go to peice.
Yes, the shorter mouthpiece is more harsh. I have to use the lower temps with my Air. You can also use a Solo mouthpiece and that extends the air path, but less stealth.
 

$un

Well-Known Member
Has anyone made a face off video of the Arizer air & the solo? Would be good if someone made a compression between the two in this thread. I tried looking on Youtube but there's nothing yet.
 
$un,

rakka

Vaped
Question, is it normal for the lights that indicate battery level when charging to flicker before becoming solid? E.g when its on 3 lights, the 4th starts flickering for a while then becomes a solid 4, and so on...

I hope there's nothing wrong with my almost new solo D:
 

OF

Well-Known Member
Question, is it normal for the lights that indicate battery level when charging to flicker before becoming solid?

It's all normal. Enjoy your Solo.

Yep, it's just 'dithering' between (say) 2.99 and 3.00. Ignore it. Often this is masked or damped by introducing an offset. Like you home heater, when set to 72 degrees it doesn't 'kick on' until say69 degrees then heats to 74 before shutting down. Otherwise it'd 'chatter' at the set temperature. That compensation is not happening in Solo, the data displayed is raw. Temperature displays are typically damped somehow 'cuz it drives the owners nut otherwise.

OF
 

Dr. Soxhlet

SOLO Vaporized Cannabis is my Best Medicine
So do you have a EQ too? I recently bought one and I'm disappointed because how much material it uses compare to the solo. Yumm blueberry sour dream with solo? Damn bro you are living the dream!! LOL

Sounds like you should do the DDave conversion with shorter "cyclone bowl" and ground glass SSV wand. I understand it uses less herb with that setup. I am about to do that conversion myself.
 

ragnorak71

Well-Known Member
Sounds like you should do the DDave conversion with shorter "cyclone bowl" and ground glass SSV wand. I understand it uses less herb with that setup. I am about to do that conversion myself.

as owner of both that's a yes from me too - it does work for the EQ but I still prefer the solo. I also have a little voice (one of many tbf) that wonders if I should have just got an air instead but wanted something a little more tried and tested. This is especially true as most arizer stuff gets better as the customer base gets more comfortable with it and any tweaks can be made
 

Scott A

Well-Known Member
Decided to vape with my solo today because I havent used it in a while. I packed up a small bowl, turned it on, and cranked it up to 7 then I left the room for a minute while it heated up. When I got back it had turned its self off and now when I try to turn it on it just flashes back and forth between the #7 led and the idle LED. If I plug it in it basically does a light dance varying between showing LEDs #1-3, the idle LED, and the #7. Anyone experience anything similar or know whats wrong with it?
 
Scott A,
  • Like
Reactions: Pipes

$un

Well-Known Member
Sounds like you should do the DDave conversion with shorter "cyclone bowl" and ground glass SSV wand. I understand it uses less herb with that setup. I am about to do that conversion myself.

I actually did just that. Just got my ssv wand with the 18mm adapter but that didn't impress me either. Still needs more herbs, not much vapor quality & bowl doesn't last long. Comparing to the EQ I have had way better performance with the solo.
 

Pipes

Addicted DIY Enthusiast
Accessory Maker
Decided to vape with my solo today because I havent used it in a while. I packed up a small bowl, turned it on, and cranked it up to 7 then I left the room for a minute while it heated up. When I got back it had turned its self off and now when I try to turn it on it just flashes back and forth between the #7 led and the idle LED. If I plug it in it basically does a light dance varying between showing LEDs #1-3, the idle LED, and the #7. Anyone experience anything similar or know whats wrong with it?
What was the battery level when you turned it on?
Since it has been sitting for a while, hopefully put away with a decent charge as they do not store well on low battery.
My guess is the battery is close to dead and protection circuit on battery causing some hicups.
You can try the soft reset and if no change, let it sit for an hour and try charging again. I wouldn't keep trying to turn on without charger plugged in, as will just deplete battery more.
 

Scott A

Well-Known Member
What was the battery level when you turned it on?
Since it has been sitting for a while, hopefully put away with a decent charge as they do not store well on low battery.
My guess is the battery is close to dead and protection circuit on battery causing some hicups.
You can try the soft reset and if no change, let it sit for an hour and try charging again. I wouldn't keep trying to turn on without charger plugged in, as will just deplete battery more.
It was at 4 when I turned it on. What is the soft reset?
 

Pipes

Addicted DIY Enthusiast
Accessory Maker
Hold down both + and - buttons while plugging in the charger and hold them for 5 seconds or so. IIRC, the lights do something when you reach the time.
Level 4 should have been fine but since sitting for a while, I would not trust 100%.
 

OvaDaBong

Member
Funny, a friend and I were discussing this sort of thing over lunch today, only about narrowly defined seafood allergies. Based on what you see there, I'd have to say it's entirely possible. More so, likely. If you can smell it, then there's absolutely the possibility you react in other ways, even below the level you can smell in some cases? The point is 'it's in the air' and you're breathing that air. I'd suggest stopping doing that......

Any problem eating walnuts?

OF


I have no allergies to walnuts as they cause me no issues however i have an allergy to pineapple but ive decided for the time being to keep of the wooden stem, i will give it a month or so and give it another shot but if i get ill again i will be passing the stem off, Im sure i can sell or swap it on the forum to another Aussie FC'er
 

OF

Well-Known Member
I have no allergies to walnuts as they cause me no issues however i have an allergy to pineapple but ive decided for the time being to keep of the wooden stem, i will give it a month or so and give it another shot but if i get ill again i will be passing the stem off, Im sure i can sell or swap it on the forum to another Aussie FC'er


Good, sounds like a Walnut stem would not be a problem then? You might heavily wax the outside (several coats of hard wax, my favorite being Johnson's Paste Wax, like you'd use on the kitchen floor. Combined with a solid layer of condensate inside that should give you some protection?

Good luck with it, but in the end allergies are to be avoided I think.

OF
 

m0sh

Singer Song Writer Stoner
Hey guys,
No I'm not back yet, my shit is due to end in 14th on June, lets hope for the best...

I have a question from a friend, are the newest modules serial number starts with M1W?

m1w.jpg
 
m0sh,

$un

Well-Known Member
2z4im21.jpg


1z66nw3.jpg


New Pinnacle Pro Water Tool Attachment Kit
with Pong Adapter
by VaporBlunt
Size: 14.4 mm


I wanted to get the water tool for my solo but I'm not sure which one is the best one and which one will fit. Can someone that has more experience in this help me out? I already have the 14mm gong adapter from planet vape & wanted to know if this water tool will work fine with it. Also what's the difference between this one & the F-bomb?
 

OF

Well-Known Member
I wanted to get the water tool for my solo but I'm not sure which one is the best one and which one will fit. Can someone that has more experience in this help me out? I already have the 14mm gong adapter from planet vape & wanted to know if this water tool will work fine with it. Also what's the difference between this one & the F-bomb?

Yes, it works just fine. In fact I used mine last night. You don't need the black piece (adapter for Pinnacle) just stack it on top of your GonG stem.

F Bomb is slightly different inside, basically a push. There are lots of clones out on the cheap glass sites as well, I haven't tried them.

OF
 

$un

Well-Known Member
Yes, it works just fine. In fact I used mine last night. You don't need the black piece (adapter for Pinnacle) just stack it on top of your GonG stem.

F Bomb is slightly different inside, basically a push. There are lots of clones out on the cheap glass sites as well, I haven't tried them.

OF

I already have that $40 bubbler from pipes daddy for the solo. Do you think there's even a point buying another water tool? Is it any different than the bubbler?
 

OF

Well-Known Member
I already have that $40 bubbler from pipes daddy for the solo. Do you think there's even a point buying another water tool? Is it any different than the bubbler?

Which PD bubbler you talking about, there are a LOT of them that could work with Solo......

I have used a couple personally.

OF
 

$un

Well-Known Member
Top Bottom