Arizer Solo

ataxian

ataxian

PALE BLUE DOT
Quetzalcoatl said:
Took my pvhes gong and added 1/4 stem fine ground Earth OG. Then added 1/4 stem finely ground hash. Put Solo on 5, light tasty hits. Bump to 6, milk. Half dozen hits or so, then stirred. Flower on the bottom was an even yellow. Added two scoops of Chocolope kief, got a few hits before it times out. Restart, hit it again a half dozen times. Constantly chalks my glass. Stop about 5 minutes in for tea. Decide to add 1/4 stem of fresh ground flower mixed in. Still going strong.


I feel funny :|
Click to expand...
My goodness you know how to medicate!
 
Sativape

Sativape

Well-Known Member
Hello all,

Regarding the M1D and newer model's charging capabilities.

I had some questions regarding the standard charger, car charger and power adapter:
http://arizer.com/store/en/arizer-solo-parts/36-solo-charger.html
http://arizer.com/store/en/arizer-solo-parts/37-solo-car-charger.html
Does the standard wall charger (one that comes with the Solo) and the car charger both:
- charge the Solo and power the unit during use?
OR
- only bypass the battery completely and power the Solo for plug in use?
OR
- charges the Solo during use while the Solo uses only battery power?

Does any one know what the power adapter does?
http://arizer.com/store/en/arizer-solo-parts/32-solo-power-adapter.html
This definitely looks more powerful than both standard and car chargers.

Thanks in advance.
 
Last edited:
Sativape,
  • Like
Reactions: ataxian
omar

omar

Member
Hello again fc,

so I was going to order a pves gong and stem from planetvape a couple of weeks ago when they were both in stock but got greedy and wanted to include an o-ring that was out of stock. Needless to say the stock ran dry for the gongs and Im stuck waiting along with many of you till the 10th.

During this time I've jimmy rigged the straight solo stem into my bong and used bluetack to make it airtight. Although this has cost me a useable straight stock solo stem (chipped the head) I consider it a success and cannot wait for my gong attachment. I get higher in half the time. I tend to use 7 to see the clouds and through my honeycomb rig with ice in the stem its just like breathing.

Happy vaping fc
 
A

as

Well-Known Member
you dont need no blue tack a solo stem will fit strait in to a 14mm joint and seal

with the chipped stem you could do what i did when i broke a stem i cut it down so that when i put it in my ground glass joint it would fit but then hit the stem where it gets thicker to make a air seal just heat the tip of the stem with a torch after you cur it down to smooth it out
 
as,
  • Like
Reactions: ataxian
Detonator

Detonator

Well-Known Member
omar said:
Hello again fc,

so I was going to order a pves gong and stem from planetvape a couple of weeks ago when they were both in stock but got greedy and wanted to include an o-ring that was out of stock. Needless to say the stock ran dry for the gongs and Im stuck waiting along with many of you till the 10th.

During this time I've jimmy rigged the straight solo stem into my bong and used bluetack to make it airtight. Although this has cost me a useable straight stock solo stem (chipped the head) I consider it a success and cannot wait for my gong attachment. I get higher in half the time. I tend to use 7 to see the clouds and through my honeycomb rig with ice in the stem its just like breathing.

Happy vaping fc
Click to expand...

When I got my PVHE stem they included a free O-Ring! So dont wait just order the PVHE when you see it! it is the best thing ever! and you might get an o-ring....?
 
omar

omar

Member
as said:
you dont need no blue tack a solo stem will fit strait in to a 14mm joint and seal

with the chipped stem you could do what i did when i broke a stem i cut it down so that when i put it in my ground glass joint it would fit but then hit the stem where it gets thicker to make a air seal just heat the tip of the stem with a torch after you cur it down to smooth it out
Click to expand...
cr37Tvd.jpg


its a rig, the stem bends a bit so its not a completely airtight seal, the bluetack helps a lot actually.

I like your stem idea, will definitely give it a try thanks.
 
SpruceGruve

SpruceGruve

Bag of sand in hand,Eyeing up the gold statue
I have been playing around with my new pvhe stems and I'm not sure if I like them better than the originals.
I like the pvhe gong better than the normal gong,But I think I actually like the restriction when I'm smoking normal stems
 
A

as

Well-Known Member
i would not leave my solo on top of that bong like that you risk braking the stem more

and yes looking at it now cutting down a stem would work very well for you till you can get a GonG
 
as,
  • Like
Reactions: ataxian
N

nads

New Member
Hi All,

A brand new vapourer here!

I only just got my first vapour, a arizer solo 2014 edition a few days back.

Its been good so far, the only part i hate about it is the stem can sometimes feel loose when put in. I also occasionally seem to forget about the opening at the bottom of the stem. At times I've forgotten to tilt the solo upside down first and then take the stem out so that the weed does all come out into the solo tube.

Anyhow, i have some questions that i needed help with.

1. Im looking to get a water tool for my solo, the two that I've come across are F-Bomb and Pinnacle Water Tool. Both look very similar and are portable. The PWT is cheaper though here in UK (about £30 less). Anyone have any idea which one of the two is better one to go for?

2. If i don't go for a portable water tool, what is the best glass water bong attachment to go for my solo? It can not be huge like a Shisha. Something small.

3. Can I smoke E-Liquads in this? If So how?

4. Can i also mix the E-Liquad with the weed (then smoke once its dried) to add a flavour to it? or is the liquid required for this completely different from E-Liquad?


Thanks for your help.
 
nads,
  • Like
Reactions: ataxian
A

as

Well-Known Member
nads said:
Hi All,

A brand new vapourer here!

I only just got my first vapour, a arizer solo 2014 edition a few days back.

Its been good so far, the only part i hate about it is the stem can sometimes feel loose when put in. I also occasionally seem to forget about the opening at the bottom of the stem. At times I've forgotten to tilt the solo upside down first and then take the stem out so that the weed does all come out into the solo tube.

Anyhow, i have some questions that i needed help with.

1. Im looking to get a water tool for my solo, the two that I've come across are F-Bomb and Pinnacle Water Tool. Both look very similar and are portable. The PWT is cheaper though here in UK (about £30 less). Anyone have any idea which one of the two is better one to go for?


2. If i don't go for a portable water tool, what is the best glass water bong attachment to go for my solo? It can not be huge like a Shisha. Something small.

3. Can I smoke E-Liquads in this? If So how?

4. Can i also mix the E-Liquad with the weed (then smoke once its dried) to add a flavour to it? or is the liquid required for this completely different from E-Liquad?


Thanks for your help.
Click to expand...

1 both the same from what i read

2 it is personal preference but i like bubblers more then hydrotubes like pnwt and f bomb i have my eye on this
http://www.everyonedoesit.co.uk/onl...er-head-diffuser-bubbler.cfm?iProductID=11022
just remember its all personal

3 you can put a drop on bud then bud on top of that but i would just stick to the e cigs for e liquid


4 you could do that as well but ild just stick to weed suff for solo and e cig for nic

edit to add cheap smaller more portable blubber
http://www.alibongo.co.uk/catalog/s....html?oscsid=0fc6116822459e394dfdbc0559011386
 
ataxian

ataxian

PALE BLUE DOT
nads said:
Hi All,

A brand new vapourer here!

I only just got my first vapour, a arizer solo 2014 edition a few days back.

Its been good so far, the only part i hate about it is the stem can sometimes feel loose when put in. I also occasionally seem to forget about the opening at the bottom of the stem. At times I've forgotten to tilt the solo upside down first and then take the stem out so that the weed does all come out into the solo tube.

Anyhow, i have some questions that i needed help with.

1. Im looking to get a water tool for my solo, the two that I've come across are F-Bomb and Pinnacle Water Tool. Both look very similar and are portable. The PWT is cheaper though here in UK (about £30 less). Anyone have any idea which one of the two is better one to go for?

2. If i don't go for a portable water tool, what is the best glass water bong attachment to go for my solo? It can not be huge like a Shisha. Something small.

3. Can I smoke E-Liquads in this? If So how?

4. Can i also mix the E-Liquad with the weed (then smoke once its dried) to add a flavour to it? or is the liquid required for this completely different from E-Liquad?


Thanks for your help.
Click to expand...
Get a cheap bubbler like a D020 from http://www.dhgate.com/product/d020-...e-perc-water/175832535.html#s1-1-1|3148540035 which is cheaper than the PNWT and works way better.

18mm GonG from planet vapes for your SOLO water adapter.
 
Last edited:
Caligula

Caligula

Maximus
ataxian said:
Get a cheap bubbler like a D020 from http://www.dhgate.com/product/d020-...e-perc-water/175832535.html#s1-1-1|3148540035 which is cheaper than the PNWT and works way better.

18mm GonG from planet vapes for your SOLO water adapter.
Click to expand...

Poster should be aware that this glass ships from mainland China. IDK what that ordeal will be like in the EU/UK.

Aside from that, I suggest the poster get a small bubbler like the one you linked versus a hydratube... however if you go the HT route, just get whichever is cheaper. The difference between the FBomb and the PNWT is negligible IMO.
 
DDave

DDave

Vape Wizard
Accessory Maker
A song, my friends, to celebrate!


Hits from the Gong!

Inhale! Exhale!
Just got my gong in the mail!
Oh.....I prefer a loaded stem, over a fat burning bowl
and now my gong-equipped Solo's getting me stoned!
It's killer! With ice included, more-chiller!
There's a bit of water in there too, don't spill her!

Goes down smooth --- these pure tasty hits
Of the funky skunky smelly green sh-t.
So, sing my song, vape all night long...
As now my solo is Gonged!

:rockon:

Vape On!
 
Caligula

Caligula

Maximus
Kaptan said:
I have been really enjoying this configuration recently. :science: I'm getting amazing clouds, cool vapor, and great taste on 4. :smug:
5DiVDv4.jpg
Click to expand...

More info plox! Also want links on where to buy.

Also tried this with my dirty stem just now!

I let the Solo heat up with the empty stem (set to 7). Had it sit until the lower exposed portion of the glass was pretty warm to the touch.

Removed stem and packed as normal then reinserted packed stem and set the heat to level 5. Let the temp drop and stabilize.

While this was happening, the oil that had condensed inside my stem had liquefied and had dripped down en masse into the packed herb.

MASSIVE CLOUDS.
 
clouded vision

clouded vision

Well-Known Member
Unscrew the cap so you can push it from the top and pull the nipple through at the same time.

@Caligula that is just a dry mouthpiece from a VXC (looks like there might be a lo pro adapter on there as well), I am however inspired and think I may have to try it myself. Should do an excellent job of cooling the vapor without losing flavor thanks to the longer path.
 
Caligula

Caligula

Maximus
clouded vision said:
Unscrew the cap so you can push it from the top and pull the nipple through at the same time.

@Caligula that is just a dry mouthpiece from a VXC (looks like there might be a lo pro adapter on there as well), I am however inspired and think I may have to try it myself. Should do an excellent job of cooling the vapor without losing flavor thanks to the longer path.
Click to expand...

Will that work with a standard gong? And if so is it 14 or 18mm?
 
Caligula,
  • Like
Reactions: Kaptan
You must log in or register to reply here.
Top Bottom