Thermovape Evolution 3.7v (limited modded HP version)

Status
Not open for further replies.
jambandphan03

jambandphan03

in flavor country
This is not your average Evolution vaporizer. This is one of the limited run High Powered 3.7v that ramps up in temp faster than the original did. I found it takes about 15-20 seconds to get to full heat which was good compared to the 30+ second heating time on the original version. Only used a few times. Asking $60 shipped. USPS priority. No trades please, US and Paypal only. PM if interested.

exaZGrR.jpg

iObth7T.jpg
 
deadheadbill

deadheadbill

I can see clearly now the smoke is gone...
Showing my ignorance, but I would still need to buy a battery for that?
 
deadheadbill,
jambandphan03

jambandphan03

in flavor country
The Evolution works best on Thermovape battery supply or one that performs equally to the Thermovape power supply, with no electronic parts to minimize the current. It will not work with Ego style batteries, it gets way too hot and requires too much power for the ecig batteries to handle. Trust me... I've tried and fried.
 
A

Ace.357

Well-Known Member
I recently acquired a T1 and was wondering if the Evolution can be used with the T1 body.
 
Ace.357,
  • Like
Reactions: ogcook
ogcook

ogcook

Well-Known Member
Ace.357 said:
I recently acquired a T1 and was wondering if the Evolution can be used with the T1 body.
Click to expand...
Yes! You can either try and source an Evolution/Revolution 510 adapter or unscrew the heating element from the T1 and use the threaded adapter there! It won't look as nice but it sure gets the job done!
You will need one of the larger low volt batteries though!
 
ogcook,
jambandphan03

jambandphan03

in flavor country
yes, as ogcook said, you can unscrew the bowl portion of the T1 and expose the 510 threaded port where the Evo would screw in, it will just not look as nice as it would if you had the other adapter they sold to go with it. You would also need to use the 17650 3.7v rechargeable battery (AW is a good brand), as this is a low voltage device and 6v would certainly overload the coil.
 
jambandphan03,
  • Like
Reactions: ogcook
A

Ace.357

Well-Known Member
Thanks for the quick response ogcook and jam. With the T1, I noticed that a pair of batteries would only be good for 1 bowl. Is the Evolution similar? One 17650 battery = 1 bowl?
 
Ace.357,
jambandphan03

jambandphan03

in flavor country
That's a tough question for me to answer, I would venture to say your best performance will always be with a fresh charge, and I used my other LV HP Evo on the Ultra w/ the smaller 14500 battery, and that would give me a load per/battery, so you are likely to get one, maybe 2 loads for sure with the 17650. I also think it depends on load size, I like to pack my chamber pretty full, leaving it loose enough for good airflow.
 
jambandphan03,
ogcook

ogcook

Well-Known Member
Mine is the higher voltage so I can't comment on this one. :shrug:

You will be happy though! My T1 packs more punch but this is nice for more smaller bowls.
 
JCat

JCat

Well-Known Member
Accessory Maker
jambandphan03 said:
$50 shipped US only please :whoa:
Click to expand...
Can't these be boiled though jam? And if so ... what's the issue with sending to Canada?

Edit: I've sent and received a lot of vapes to and from the US and I'm in Canada ...
 
JCat,
Status
Not open for further replies.
Top Bottom