Vaporware

Well-Known Member
You asked.
Yes, a change for the worse...any vaping, btw.
I have to take two-week breaks now and again for my trachea to recover [edibles during].

Hard to believe any claim it'd be good for you.
Pot resin is so sticky on yr delicate tissues. :-)
[Maybe I've tenderized my lungs from decades of second-hand smoke playing nightclubs for so long?]

It probably depends on the frequency of use, your body, the specific vaporizer and how you use it, etc.

There’s a big difference between using a VapCap for 3 light heat cycles a day and using it at near combustion temps 30 times a day for example. Or setting a moderate temp on a conduction device vs a high temp on a short stemmed convection one.

Cannabis (apart from smoking) has actually been shown to help with asthma though, and I think the same effect may also help the breathing of users without asthma.
 

davesmith

Well-Known Member
Glass Blower
Theyre great! Def recommend 2 tho so you can keep 1 in cleanin solution while using the other. Im really a torch and banger kinda guy when it comes to ccomcentrates but was amazed how good the coil was considering.
Cheers friends, I'm bout to spin one up!

I just got the DynaCoil yesterday from VGoodiez.com and haven't tried it yet. :)
 

roonsy

Well-Known Member
Got back from vacation and this was my travel kit:

21c9frt.jpg


Stealthy M (Shadow SS M tip, carbon fiber stem, Blackwood mouthpiece)
Classy Ti (7fin Ti LE, Omni stem, spinning Ti mouthpiece)
2x Aomai lighters
Alfa
Mint case (accommodates 2x XL Vapcaps and one Aomai lighter)
Cyclone II (triple torch)
Butane

Can you find it :)

akbaf4.jpg


And always a lovely combination

2ytxpfl.jpg


Have a great weekend everybody :wave:

Woah I have two of those mint cases (unopened from a trip to Nintendo New York years ago) that I was about to just throw out... not anymore! ;)
 

Dynalowrider

Well-Known Member
How I keep my screens cleaner to make them last longer. First to replace them in the VC I back them up with a 4mm ss axle up the condenser to flatten them after installation. I took a dremal brush, with the bristles straight out the end. I clamp it in a "pin vice" with a 1 inch straw on the shaft to compress the bristles enough to get them in the bowl. I slide the straw back after I get them in the bowl to brush the screen off in the bowl. I've been with a Dynavap since early 2016, and the only screens I have replaced in all that time is when I had a "Jesus" moment and it flew through the air. You have to hold your mouth right and they will stay in if you DON'T PACK it down so hard it buckles the screen. Doc
 

muunch

hotboxing the cockpit
HI guys - I did a quick search on this thread and didn't see anything immediately enlightening....so, does anybody know where George and Dyna are with their IH?

Back burnered, dropped, or imminent?

They addressed this in a Dynavap live some months ago - They are still working on it, but it is challenging to bring an IH to market that is both mass-produceable, and also safe.

I'm sure we will hear more before the year is up.

It is definitely not dropped though.
 

beyond6strings

Just another traveller in the Cannaverse
Is it worth perusing??

Certainly worth perusing, but only you know whether it's worth pursuing.

I can only imagine the hits you'd get once you figure out how to get to all the caps to click at the same time.

I've been a bad Dynapper. I looked at my Dynavap account and I've not contributed to the community coffers in almost a year.

Don't really need much, but I scored some SS and Ti screens. Those I need-most of my screens are pretty nasty.

Back to life on the deck.
 

Squiby

Well-Known Member
@phattpiggie

That triple is stunning! It's certainly more elegant than your original hand carved version of a triple.

One cap at a time suits me, 'cause I'm a lightweight. But I can think of several people that are always looking for ways to up their Vapcap game. Your new triple may well be their ticket!
 

phattpiggie

Well-Known Member
Accessory Maker
@beyond6strings sodding auto correct. Persue.

@Squiby this is the stem/s you are on about and it's two years ago. Time flies.
No problems getting all the caps to click one after the other if your spinning technique is good.
@Pipes has been primed for a TIH.
More usage videos to come, sorry for the link to IG can't find this one on the tube.
https://www.instagram.com/p/BVDS-gwjaku/?igshid=1smhjcrxmig6j
Both these are the original stem so right now I can't vouch for the new one, yet.
 

roonsy

Well-Known Member
A couple of months ago I ordered a Green Omni that went missing in transit. It still hasn't turned up and I'm assuming it never will.

But thanks to George and the others at DynaVap, I had a new one sent out to me and it arrived a couple of weeks ago.

Just wanted to say thanks to them for helping me out, I was really worried about it and am very happy to add this one to my collection... really eager for some after-market stuff now :)



Haven't been as active here as I'd like to be this past couple of months, but hope to be around again more often soon :)
 

sirwalter

Well-Known Member
HI guys - I did a quick search on this thread and didn't see anything immediately enlightening....so, does anybody know where George and Dyna are with their IH?

Back burnered, dropped, or imminent?

Last real update I can recall was some time around March and George was suggesting it would come out by this summer. Not sure if that is still true.

Around the same time he also said there would probably be a new omnivap at some point not too far off.
 
Top Bottom