Discontinued VapeXhaleLabs Presents: The Cloud

Status
Not open for further replies.
IAmKrazy2

IAmKrazy2

Darth Vapor
SM, i know you like your vape on the lighter side, as far as temp..... Just assure me that is the range used in the video, cause it looked THICK. Maybe lighting?? If i had seen someone asside from you blowing a cloud like that, i'd assume temp wise it was a bit out of my ideal range.... but i know with my current lineup in the correct lighting, i can get things pretty milky too. out
 
IAmKrazy2,
F

finchrock24

Proud MMJ Patient
I noticed that in my experiance (which is hardly any compared to most of the people in this thread) the temp on my vape/bong setup needs to be 30 or so degrees higher then the standard whip temp. I whip-it at about 190 and vapor bong around 220*...my clouds are easily comparable to that of the video on the last page...so that is probably right around the sweet spot.
 
finchrock24,
IAmKrazy2

IAmKrazy2

Darth Vapor
I noticed that in my experiance (which is hardly any compared to most of the people in this thread) the temp on my vape/bong setup needs to be 30 or so degrees higher then the standard whip temp. I whip-it at about 190 and vapor bong around 220*...my clouds are easily comparable to that of the video on the last page...so that is probably right around the sweet spot.
Click to expand...
Not in my opinion. With my E, i do not go up in temp just because i have some glass and ice. If anything, i may be inclined to go down temp with some vapes. Whip or glass from my E i start around 185 end up around 210.

PD's which have a constant temp, brown up the herb even more when using a glass hookup. So without raising the temp, things already vape up at a higher level.
 
IAmKrazy2,
stonemonkey55

stonemonkey55

Chief Vapor Officer
Manufacturer
Here is the YouTube version of the link as well - http://www.youtube.com/watch?v=D4BoYT-n_Z8

@IamKrazy2 - It is indeed low temp vapor. The reason it looks so thick in the video has to do with lighting, high quality THC concentrated herb, and the heat retention properties of the Cloud. Admittedly, the same demonstration under bad lighting conditions will not look nearly as impressive but that is due to the properties of vapor and is not unique to the Cloud. If it is a sunny day and you do the same thing I did with some sunlight shining through the tubes, you will definitely get similar, thick, milky, bluish vapor
 
stonemonkey55,
luchiano

luchiano

Well-Known Member
Do you plan on making any bent necks?. I get a better inhale from them because I can expand my diaphragm which helps suck in more vapor as opposed to a straight neck where I have to bend over and can't utilize my diaphragm as much leading to less vapor.

Also, do you plan on having a digital display or something that lets you know approximately what temperature your vaping at like the volcano classic?. This would be needed for me because I like to know the temp so I can vaporize certain chemicals in the plant at intervals so I can preserve and experience them on their own without degradation and this vaporizer would be good for me to just take each level of chemicals in a quick rush when I just want to get blasted and I'm on the move. The only option now is smoking but that doesn't allow me to do what I just described. Herborizer is a good option but I don't like big bongs because they dilute the vapor with too much air and your pieces are small enough to keep the vapor from being diluted too much.
 
luchiano,
F

finchrock24

Proud MMJ Patient
IAmKrazy2 said:
I noticed that in my experiance (which is hardly any compared to most of the people in this thread) the temp on my vape/bong setup needs to be 30 or so degrees higher then the standard whip temp. I whip-it at about 190 and vapor bong around 220*...my clouds are easily comparable to that of the video on the last page...so that is probably right around the sweet spot.
Click to expand...
Not in my opinion. With my E, i do not go up in temp just because i have some glass and ice. If anything, i may be inclined to go down temp with some vapes. Whip or glass from my E i start around 185 end up around 210.

PD's which have a constant temp, brown up the herb even more when using a glass hookup. So without raising the temp, things already vape up at a higher level.
Click to expand...
Interesting to hear that...I will try my next bowl at 185 and see what happens. When I first got my glass I tried around 200 but the hits just weren't quite thick enough to satisfy and at 220 they are almost overwhelmingly big so I just kept her there.

Time to pack a freshy and fire up some Alice in Wonderland...haven't seen it yet!
 
finchrock24,
IAmKrazy2

IAmKrazy2

Darth Vapor
At the lower temp, you might have to let it preheat a little longer to get the thick hits. Keep in mind, i always pack the ellbow, even if i am packing both the elbow and cyclone bowl. Also, the EQ may run at a slightly diffrent tempurture, then the E, but i am uncertain.

depending on the herb, 190 degrees is the ideal temp IMO. I do turn it up 5 degrees at a time from 185 to 210, usually staying at 190 degrees for the most hits, and 210 for the least number of hits.

With variable temp vapes, starting low and slowly working your way up is the best method IMO. As usual, especially on low temps, the first couple of hits are small but once the bowl gets roasting a little, you'll get some thick tasy bluish colored clouds. yum!
 
IAmKrazy2,
max

max

Out to lunch
Also, the EQ may run at a slightly diffrent tempurture, then the E, but i am uncertain.
Click to expand...
As far as I know only the sensor placement has changed since the 1st version of the E was introduced. And none of the versions has a true vaping temp on display, as far as revealing the actual vaping temp in the bowl.

"There are currently 3 revisions of the Extreme. The only way for you to be certain of which version you have is to turn your unit on and dial the temperature to its maximum setting and see how high it goes.

v1 - 350C
v2 - 250C
v3 - 260C
It's important to understand that the temperature of the element and the air hitting the herbs is identical in all 3 revisions. The only difference is the temperature reading on the display."
http://www.vaporpedia.com/wiki/How_To_Use_The_Extreme_Vaporizer
 
max,
stonemonkey55

stonemonkey55

Chief Vapor Officer
Manufacturer
@luchiano - we will possible make some bent shape tubes in the future but the initial HTs will be straight. If you want to be able to open your diaphragm, you can always lean back and use the Cloud, it is very easy to use it that way as well. The Cloud will launch with an analog model. A digital model will be available in the future but no timelines for that product have been released.
 
stonemonkey55,
F

finchrock24

Proud MMJ Patient
IAmKrazy2 said:
At the lower temp, you might have to let it preheat a little longer to get the thick hits. Keep in mind, i always pack the ellbow, even if i am packing both the elbow and cyclone bowl. Also, the EQ may run at a slightly diffrent tempurture, then the E, but i am uncertain.

depending on the herb, 190 degrees is the ideal temp IMO. I do turn it up 5 degrees at a time from 185 to 210, usually staying at 190 degrees for the most hits, and 210 for the least number of hits.

With variable temp vapes, starting low and slowly working your way up is the best method IMO. As usual, especially on low temps, the first couple of hits are small but once the bowl gets roasting a little, you'll get some thick tasy bluish colored clouds. yum!
Click to expand...
Okay, I'll try that...however I don't pack the elbow...or the cyclone bowl. I just use the Q as a heat gun with my glass.
 
finchrock24,
stonemonkey55

stonemonkey55

Chief Vapor Officer
Manufacturer
Quick question for you guys... so after seeing the demos for both HydraTubes, did that make you change your mind on your initial choice. The good news is, as we are waiting for the Cloud, we are stockpiling quit a bit of inventory for these tubes so if anyone needs to make a last second change, or wants to order more than one, we should be ready to go!
 
stonemonkey55,
H

honeboy

Well-Known Member
After seeing the demo videos I am inclined to switch form the showerdome to the hydratree. Both look great though!
 
honeboy,
stonemonkey55

stonemonkey55

Chief Vapor Officer
Manufacturer
HAHAHA, if there is something sicker than Sovereignty, then someone needs to let this monkey know!

After spending more time with these two Hydratubes, I can honestly say that there really is no loser between these two. As with anything in life, some people prefer blondes while others like brunettes. I say, why not have a threesome? More glass porn to come :D
 
stonemonkey55,
S

sLug215

Well-Known Member
My preorder is for the gridded hydra, really looking forward to those, but the VG looks to nice and I'm picking up a vg circ bubbler soon I think, would make a nice couple.

Also, question. Will you be offering the cloud sans glass? For people who already have glass they'd like to use with it?
 
sLug215,
ShadowLink12

ShadowLink12

Activist
stonemonkey55 said:
Quick question for you guys... so after seeing the demos for both HydraTubes, did that make you change your mind on your initial choice. The good news is, as we are waiting for the Cloud, we are stockpiling quit a bit of inventory for these tubes so if anyone needs to make a last second change, or wants to order more than one, we should be ready to go!
Click to expand...
I don't know if I have necessarily changed my mind, but I do feel VERY conflicted. I went with the Showerdome, and am thinking about switching now. I have actually never hit either kind of perc. I like the room for ice in the hydratree, and I like the recessed joint of the showerdome. I am sort of leaning toward a possible both option. What price range would we be looking at for a double hydratube package deal on day one?
 
ShadowLink12,
dawson_canuck

dawson_canuck

Well-Known Member
I still really want the VG tree hydra tube. Still waiting on a reply for the pre-order,,, does being in Canada exclude me from the action?!
 
dawson_canuck,
stinkmeaner

stinkmeaner

Well-Known Member
stonemonkey55 said:
@ stinkmeaner - we're still finalizing on the design of the SG HydraTube, since we had some extra time to work on the enclosure, we're just playing around with a few different designs til we "get it right"
Click to expand...
Thanks for the reply, I don't know if you have the answer to this question yet but I figured it won't hurt to ask. Do you know if the joint style on the Sovereignty hydratube will be recessed like Stone Glass Works version or will it be like the Vertigo version?

I love the way the recessed style looks.
 
stinkmeaner,
stonemonkey55

stonemonkey55

Chief Vapor Officer
Manufacturer
@slug215 - The VapeXhale Cloud only comes in packages. We plan on offering the Cloud as a standalone unit in the future but the powers that be have not come to a conclusion for that date yet. The Cloud was designed to be used this way and the fact that it works with other glass pieces happens to be the icing on the cake.

@shadowlink12 - I've been working with the team of glass blowers on ways to create the HydraTubes in more of an assembly line fashion to lower costs so I will hold off on giving an exact number. A good way to get some ball park figures would be to go to a site like Aqua Labs and see how much they are charging for SG, SGW, and VG glass pieces. If you want to add an extra Hydratube during the launch period, I am confident in saying that it will fall somewhere in the 150-250 range.

@dawson_canuck - I'll send out a quick email over the weekend to everyone that registered, if you didn't get one, email support@vapexhale.com and I'll make sure you are on the list

@stinkmeaner - It will be recessed :) SG FTW :D
 
stonemonkey55,
IAmKrazy2

IAmKrazy2

Darth Vapor
Quick question for you guys... so after seeing the demos for both HydraTubes, did that make you change your mind on your initial choice. The good news is, as we are waiting for the Cloud, we are stockpiling quit a bit of inventory for these tubes so if anyone needs to make a last second change, or wants to order more than one, we should be ready to go!
Click to expand...
SM, i do want to switch from a showerdome to the tree if possible. how would i go about doing this?? thanks,.
 
IAmKrazy2,
S

supercrazy

Well-Known Member
I am very interested in buying this product as soon as possible!!.Problem is i live in England.Will this product be useable with a power convertor?.If not when can i expect to see a uk mains version.Desperate to quit combusting and enjoy the health benefits...
What ya think Stone Monkey?
If it is useable with a power converter i will sign up 4 1?

cheers
 
supercrazy,
stonemonkey55

stonemonkey55

Chief Vapor Officer
Manufacturer
@iamkrazy2 - we are currently ramping up production so we should have enough of each in case everyone that pre-orders wants once of each. All the percs and diffusers have been made, we're just toying around with different manufacturing processes to figure out how to assemble these faster and better.

@supercrazy - Yes, you can use some sort of power inverter with Cloud. Cheers to the other side of the Pond!
 
stonemonkey55,
Status
Not open for further replies.
Top Bottom