DNA 200 profile for Saionara

Tranquility

Well-Known Member
I'm going down the rabbit hole and have a mod that uses DNA 200 and the EScribe software to set the vaping style for different mods, coils, atomizers, etc. Does anyone have a profile they use for the Saionara? If not a profile, how about just the proper settings? It seems like there are many options to get the best experience and I don't know what many of them mean. A good guide would be useful.

I understand the miracle coil A in the Sai might be best fired between 7-15 watts and the wax coil between 18-27 watts. (As expressed on the ordering page for the vape.) However, there are many other potential options that could change things.

One reason I am confused is that I did the recommended "burn off" of the coil by pulsing twice at 12.5 watts for five seconds. The ceramic glowed red and I got a little of what I assume is manufacturing oil to burn off. However, even with the red glow and burn off, the EScribe software listed (Using Device Monitor.) a "Temperature" of a little over 300F was shown.

How is that temp derived and does it represent a calculation of temp at the coil based on input, or something else? Does the fact the temp list at about 300F mean that with the current set up and at 12.5 watts I will be vaporizing (along with terpines) only the cannabinoids that boil below that temp? (THC-A, CBD-A, CBC-A) I know I will start low and work up. I'd just like to know a little more about what I am doing.
 
Tranquility,

flatulentz

Member
When ceramic glows red it's a LOT warmer than 300F, so I wouldn't trust the temp the box says it is.

I didn't have much luck TC-ing it and just run the Sai at 8W-10W in power mode.
 
flatulentz,

Tranquility

Well-Known Member
When ceramic glows red it's a LOT warmer than 300F, so I wouldn't trust the temp the box says it is.

I didn't have much luck TC-ing it and just run the Sai at 8W-10W in power mode.

Thank you for your reply. From what I've read, the Sai with the miracle coil(s) or the wax coil should probably not be run in TC mode. I was running straight power mode (With a temp limitation of 450F.). I agree the red glow seems to indicate more than 300F which is why I questioned it in the first place.

I think your recommendation for the power range for best result is probably going to be my range as well. We'll see.
 
Top Bottom