1. What does SSTB mean? See our glossary of acronyms.
    Dismiss Notice

polykoma's Recent Activity

  1. polykoma liked ghost's post in the thread She does not like me getting high.

    Your "girlfriend" doesn't actually like you. She likes the imaginary image of what she believes she can force and mold you into for her...

    May 22, 2018 at 2:11 PM
  2. polykoma liked Pipes's post in the thread VapCap Induction Heater for Desktop and in Car Use.

    The BMS does have over voltage protection but it's rather high at 4.3 volt area. If the batteries were not new, this may have damaged...

    May 21, 2018 at 8:31 PM
  3. polykoma liked Edgedamage's post in the thread VapCap Induction Heater for Desktop and in Car Use.

    Watching the disassembly video, if you open the bottom the lipo is right there. If yours is puffed looking like a pillow it is damaged.

    May 21, 2018 at 8:31 PM
  4. polykoma liked Pipes's post in the thread VapCap Induction Heater for Desktop and in Car Use.

    Use it for a for a couple cycles and see if things improve. This may just be a mis-reading of the battery indicator. You might have...

    May 21, 2018 at 8:31 PM
  5. polykoma liked Pipes's post in the thread VapCap Induction Heater for Desktop and in Car Use.

    Many supplies have trouble, even if rated over 6 amp. Here is what I wrote about it a few pages back. 8+ amp rating would be less likely...

    May 19, 2018 at 10:11 PM
  6. polykoma replied to the thread VapCap Induction Heater for Desktop and in Car Use.

    The FAQ says: Optional Stuff: 12 Volt Power supply* - $15 (comes standard with Jarhead, optional for battery powered units.) *Not to be...

    May 19, 2018 at 7:21 PM
  7. polykoma liked Pipes's post in the thread VapCap Induction Heater for Desktop and in Car Use.

    Was using round standard LEDs, now I use the square type as easier to fit into place. :science: 3 in series and a 470 ohm current limit...

    May 19, 2018 at 12:36 PM
  8. polykoma liked V-apE's post in the thread VapCap Induction Heater for Desktop and in Car Use.

    @polykoma,I'm not 100% sure but i believe Pipes uses flat leds. [IMG] Make sure they are 12 volts:D Edit: Look at the third picture...

    May 19, 2018 at 11:21 AM
  9. polykoma replied to the thread VapCap Induction Heater for Desktop and in Car Use.

    Ahhh okay - since im kinda LED junky i know strawhead means - rounded led with a sawed off head. I used them once when i put an...

    May 19, 2018 at 11:20 AM
  10. polykoma replied to the thread VapCap Induction Heater for Desktop and in Car Use.

    It would be so fantastic if the used LEDs for the glass chamber could be added to the parts list. I ordered some but I'm not 100% if...

    May 19, 2018 at 9:15 AM
  11. polykoma liked Pipes's post in the thread VapCap Induction Heater for Desktop and in Car Use.

    The BMS is in the wire harness where two wire split into the multipin connectors. It is a small board. (HX-3S-01) [IMG]

    May 16, 2018
  12. polykoma replied to the thread VapCap Induction Heater for Desktop and in Car Use.

    ahhhhhh its just another version of this BMS - thank you so much for the fast response. I checked my orderlist and its already ordered....

    May 16, 2018
  13. polykoma liked mrb's post in the thread Best Of Dynavap VapCap.

    Adjustable M anyone? Used two stainless steel Circlips to sandwich the screen in a small bowl position on my M tip. Works a treat!!...

    May 16, 2018
  14. polykoma replied to the thread VapCap Induction Heater for Desktop and in Car Use.

    I ordered the battery pack you stated on the FAQ. So i should order a BMS for this pack also? I was sure it is not needed since the...

    May 16, 2018

Support FC, visit our trusted friends and sponsors