Recent content by KRnoS

You guys are wizards honestly, yes it does say SME so it must be sur_myevic I think I’ll just buy new cells instead of trying to resurrect. Seems easier. Humorously, I bought a ghost MV1 years ago during their liquidation or massive sale. Since I can’t use the Splinter Z yet, I tried charging...

Thank you everyone. Yes, I did crosspost and I appreciate the responses. I figured I would be able to get an answer somewhere. FWIW - I think I installed arctic fox since that sounds familiar. So it might be a bit of a wait before I can try this out again. I had left the batteries in the Gen3...

Thanks! But I think I already installed some custom firmware on it with a guide here but no idea what version or what it was called. Should I flash it back it to factory defaults and re flash it or something ?

Hey all. Getting back into the hobby after like 3 years and I found my Reuleaux (was once recommended here, I think Gen3 at the time) and a Splinter, Splinter Z and Stempod with some assorted mouth pieces. In the past, I found this setup to be finicky but re-reading the old rave reviews...

Reuleaux RX GEN3 Dual Mod

I'll go slower tonight, but I feel like I've been going slow (not my first vaporizer). I'll report back

I've been trying my Splinter Z on 33w-38w but getting poor results. Long hit, feathering the fire button so it doesn't cut off, and yet I get very whispy hits. My ABV also doesn't get brown/dark brown. Only yellow-ish I'll try again tonight but I can't understand how some people can be in the...

So I got my Splinter Z and installed the sur_mevic firmware on my Reuleaux RX Gen3 Dual. the Z seems to be reading at 0.37 ohms and I wanted to try out the TCR mode. I have it setup as: 370 degrees Fahrenheit M1: 160 M2: 100 M3: 110 NI: TFR TI: TFR SS: TFR PW: SS -- AutoFi: On ATime: Infinite...

Vgoodiez got their sale up and I picked one up (also couldn't resist and picked up a MPL Stempod SI since it was 20% off as well at the official site). Picked the Z over the regular splinter because it can't hurt if it's stronger. I'm actually rethinking my mod selection. Lots of (e-cig)...

Splinter Z will be my next vaporizer, and since I'm in the USA, I'll be picking it up from PuffItUp. Now the question is if I want to wait until the 4/20 sales start to trickle in. Hmmmmm

The INH4 was my fault driver before losing it. Really enjoyed that device a lot, but my VAS took hold and I now have like 6 different vapes.

Thanks guys! I'll give the hints a try when I'm home later today.

Hi all, I have a question about the little screen on my new Blackwood onnivap I removed so I can see if I can adjust the bowl size to a smaller chamber. I just can't seem to put it on correctly though. It keeps going in at an angle and installs looking like "/" I viewed a video on their...

My Blackwood OmniVap arrived and I have a couple of questions ! I tried using the MFLB herbal blend of "Feelin Fine" and almost had no favor cloud output. I tried adjusting the mouth piece but it doesn't seem like it's making adding anymore resistance to the air path. Should I be using the...

I finally got around and submitted another warranty claim. This time I took a better video of my issue (that I had since I received it): Turning the temp dial causes the unit to have its lights turn on/make noise, etc. The first time I submitted this they said it was normal. Now they want me...