I am running the iJoy INR 26650 . It is 4200mAh 40A (or so the label says).
No issues with running the QQ or several of my different wax RDA builds at long sustained high wattage.
So part of what makes this mod such a great pairing with the Quartz Quest is exactly that unique part of it's design.
The 510 plate is actually recessed below the lip of the top of the mod. The mod then includes a 'beauty ring' which screws into the top. This provides an excellent heat...
How did this turn out? I'm very interested in getting a larger FQN that mates perfectly with the Errlectric coil if possible. As other have pointed out you need to use a small amount of concentrate to avoid drips down the stem of the standard FQN. While this is actually somewhat helpful in...
Yes I am using a box mod. When the chimney flooded I just powered through it in straight wattage mode, no preheat. I use 19w and pulse 3 secs. I would be careful at that power though. Remember to use short pulses. Start inhaling for a few seconds before your first pulse and keep inhaling...
FWIW I am 4g deep only using distillate with added terps (extremely thin when heated) and no leaks. Chimney flooding yes but that hasn't led to any leakage for me. I can also power though the flooding in wattage mode. I just really want to use TC. That is one of the key selling points of the...
Yeah this is exactly my experience. No leaks but about half way through (running in TC) it flooded the chimney. It still works great in wattage mode just like you said but it always starts off after resting for awhile in a clogged state.
My plan was just to finish the tank in wattage mode...
I think in my mind I had inadvertently munged the prototype QQ you have with the heaters in the final release. Meaning I thought Matt had actually gone the route this time of a coil inside the alumina tube. You are of course absolutely right, now that I look at the picture of the tubes again...
Glad to hear there is no solder and that is not surprising given @divinetribe knows his stuff by now.
However, you can clearly tell from the pictures that the air path is in no way isolated from the heater. The heating element is entirely exposed and most liking has to be in this current gen...
I run at 550 F on my enail and usually get 3-4 solid hits before the flavor turns and I stop and q-tip. I'll actually try timing myself but I doubt o am hitting a full 10 sec inhales. My lung strength degrades as the years pass hah!
The good news here is it seems at under 600 F we aren't...
Great video and the best look we've gotten so far at the heater. Hopefully we'll see a full tear down of this soon.
It would appear to be similar tech to what Longmada has been using in their "Glow" series. A ceramic rod with a wire running through it that slides into a hole in the bottom of...
Not trying to be rude but why on earth are you not q-tipping it clean? That rock solid crud that builds up has to taste disgusting for the next dab? Sorry not trying to flame you just genuinely confused.