Dude, you folks are great.
@Caligula Thanks for the demo, and the link to the extract thread. That E-Nano looks amazing. I love my Vapor Bros so far, but will eventually want to get a new piece.
@KidFated. Thanks for asking for me----I had no clue this even existed.
Everyone else: Thanks for...
Alright, reporting back that you're totally right. It wasn't an inlet at all. You'd think I'd checked *after* I used it.
Awesome, thanks for the advice! I'll do some camera shooting to figure it out (I am using smaller loads on low temps).
Wait, so it doesn't really matter *where*?
My 'concern' is that filling it to the red would cause the water to leak out.
Filling it to the blue means that the water won't pass through the perc.
Green seems right, but... super precise?
Also, I should point out that I'm new to the bubbler...
I just bought this new piece and, while I feel stupid for asking, I'm not sure how high to fill the water.
Any help? Should it go up past the second inlet hole (into the main chamber) or should I leave it lower than that? I feel as though if I leave it lower, then the vapor isn't forced through...
Here is the one I have: http://www.vaporwarehouse.com/site/vaporbrothers-hydrator-clear-precision.html#.UyerFvldWt8
It's great, but I busted the stem (not the mouthpiece side, but the one that connects to the whip).
I don't really want to spend $120 again quite yet since I've only had it for...