Do NOT click on any vaporpedia.com links. The domain has been compromised and will attempt to infect your system. See https://fuckcombustion.com/threads/warning-vaporpedia-com-has-been-compromised.54960/.
The Screwball Mascot Naming Contest is live! Enter before March 17th at 11:59pm PST to win a Screwball Starter kit and other cool stuff
Most of the episodes would revolve around whether to get off the couch or not.
Vapgirl: Vapman! The village is overrun with weed eating squirrels!!!
Vapman: Yea yea that’s cool, have you seen my new LBV?
Vapgirl: No, break that bamma out.
*two hours pass, still on couch*
Butler Chong: Sir...
Yep, the ID of the 1/2” nipple is 0.65in / 16.68mm.
I’d stick with clear glass. Frosted halogen lamps run a bit hotter. Might work out though. Don’t really know. I’m using a Satco S1924
Lower wattage should work fine. Just a bit slower. 75W may be the sweet spot.
Lamp stand?
Edit: Thanks @Stu
Polish the midsection with sandpaper starting with 220 stepping through grits to 1000 grit. Then I moved to metal polish. I used a stick with a slit in it to hold the sandpaper and paper towels. Then I spun the tube. I could spin the stick in a drill. Simple flap wheel.
It is necessary to keep...
You would not believe the whining that went on when boy blunder saw that chunk of Fir.
So finally he gets some Cherry wood 8/4 true aka 2” thick. (This is a good choice of wood)
I cut it into 2x2” blanks
This one is using the screw base linked above.
I think this is going to work well...
Still draining battery. I think it’s lasting this long just to spite me.
I will prevail :sherlock:
Edit: Got it done 7.4V under load (sag) then 7.7V (rested state)
That makes sense for cells this size.
All I said was the tape was pretty good quality. There are two heating elements, one inside the other.
The white goo used to seal the bottom of the heating chamber where the wires enter the air path is the most likely culprit. IMO