Recent content by 420time

I figured it out with temp control! TC Ni 410f+ at 14w and locked resistance at .8ohm. Lovely vapor production but needs a 4-5 second heat up. With only 1/4th of an air flow hole open.

As long as the replacements are cheap I am fine with it breaking so easily. In my opinion temp control is nice but its just not for the source nail. Only way to get the best out of it is use it in vw mode. Idk if its just me but it seems like the ceramic coils i got from Matt seem to die out...

What is a good temp to start at with the source nail? Also is it a good idea to lock the wattage too? Received my coils, they were really easy to rebuild. I started toying with the temperature and gotten decent vapor production at 450+ with 3 second preheat. The watt at 22.5 and resistance...

Any idea on if locking resistance is a good idea?

It works best at 18.5w-22w. 20w+ for 2-3 second preheat and 22w for practically on demand hits but leaves the bowl a bit of residue. To me the residue is fine as i tend to torch clean the bowl and ring couple of times of day to get the freshest taste. Besides that, i should be receiving my 7mm...

I clean mines twice a day, and even at that rate the oil still steeps into the threading of piece that keeps the bowl tight. Torch the ring clean and the ti bowl clean, most simply way to clean.

That is what i use to do with the ceramic cup i had from puffco. plus. Now the ti bucket i can just take it out and torch it clean whenever i feel like.

That is true but it looks more stoner proof. Since the smaller nail i use i tend to always touch the metal ring on top or a oil drops and miss when loading. The increase in size of the XXL dish i feel it may increase the load amount but also just create a lot of reclaim taste unless they explain...

They do have a ceramic heating plate, but that is only for the XXL models, which just came out recently. Well with what is currently used with the source nails is just a ceramic cup under the ceramic donut inside the atomizer. Even though its a very simple design im pretty happy with it so far...

On DT's website the ohm could be between 1.5 or .8. As long as the voltage isn't past 4.2 with .8ohm it'll be fine from my experience and i use it with the Ti bucket since i can just torch it clean 2-3 times a day easily. But normally i wont run it past 3.5v until after 5 hits at .8omh then up...

does anyone have both the source nail and the divine tribe? Can the source nail's donuts be replaced with a 10mm donut from divine tribe? I have a source nail and the donut has split in two. Was wondering since it seems very easy to replace after taking it apart. Measured the donut coil from the...

dont know why it seems more like a re-brandning to me.

WHEN??? AND are they cheap to replace/easy to clean? Other sellers are 15$ per replacement like the puffco plus and Sourceorb charges 45$ for 3 atomizers, 108 for 3x3 if a 20% coupon is used. But supposedly source orbs terra 2 heats up the bottom and the sides.

can those terra coils be burned clean? continuously heated til the carbon is burned off? And when the terra 2 will be back in stock?

Its a nice pen, but expensive for replacements and it craps out easily. Either stock up on puffco plus parts at around 110$ for 9 coil-less chambers or an alternative, of figuring out which new wax pen to get. Either the source orb with the terra 2 or wait till divine tribe releases new atomizers.