2clicker
Observer
so i am putting together a homemade CO2 dry sifter box and was wondering what those of you with experience would recommend regarding the mesh/micron size of the mesh. im going with SS mesh. after looking a bit i see that around 140-160 micron seems to be normal for kits being sold online.
what i am looking to do is sift as much pollen as possible. even if that means some plant matter getting through. i will be doing a qwet run on the sift return and can remove any unwanted stuff that make it through the sift later if needed.
my goal is to extract as close to the same amount as you would with a traditional qwet wash, but this would allow for MUCH less solvent being used. less solvent to purge and way shorter evap times.
or does anyone think that i would be leaving some goodies behind from the dry sift? i can always run whats left in a traditional wash if needed i suppose.
thoughts?
what i am looking to do is sift as much pollen as possible. even if that means some plant matter getting through. i will be doing a qwet run on the sift return and can remove any unwanted stuff that make it through the sift later if needed.
my goal is to extract as close to the same amount as you would with a traditional qwet wash, but this would allow for MUCH less solvent being used. less solvent to purge and way shorter evap times.
or does anyone think that i would be leaving some goodies behind from the dry sift? i can always run whats left in a traditional wash if needed i suppose.
thoughts?