Pinnacle Hydrotube & Chandelier

rotax

Zaporist
A couple further evalutations on the PNWT.

Change water after each use, I think since there is so little, the smell really sticks in the water. Too much taste is lost vs. direct draw. For my vape, there is not enough resistance. Normally I can inhale very slowly for ~10+ seconds, slowly roasting a bowl, leaving some greens and having a couple more healthy hits. Using the PNWT I can roast a whole bowl in that same 10s or less. So, clearly the PNWT is helping a lot with lowering vapor temp since I can inhale a lot more at once. But, at the same time, it feels like its far more wasteful when efficiency is concerned. Maybe I just have to conciously take smaller hits when using the PNWT. :ko:

I've found the top holes that allow the water to fall back into the perc chamber seem to get plugged quickly with the tap water I've been using. I'm going to try an ISO clean and then see if distilled water helps eliminate that issue. If its plugging those upper slits, its bound to plug the showerhead slits soon or later.

I feel like the bottom could be a bit 'flatter', when I set it down it feels like it wants to rock back n forth a bit...and just is a tad unstable. Make sure you push it out of the way while you prep. I've bumped it a couple times and it wobbled back n forth on a balance point.

Overall I feel it does a good job of cooling vapor for my needs. Its a bit awkward to use with a log; its just not natural to use my log 'up right'. And if I weren't using an SS or brass bowl, I don't think the herb would 'pack into' and stick to a [larger] glass bowl as well.
 

KidFated.

Unknown Member
soooo should i use this with my da buddha?.. and and suggestions with a da vinci attachment?
 
KidFated.,

olivianewtonjohn

Well-Known Member
A couple further evalutations on the PNWT.

Change water after each use, I think since there is so little, the smell really sticks in the water. Too much taste is lost vs. direct draw. For my vape, there is not enough resistance. Normally I can inhale very slowly for ~10+ seconds, slowly roasting a bowl, leaving some greens and having a couple more healthy hits. Using the PNWT I can roast a whole bowl in that same 10s or less. So, clearly the PNWT is helping a lot with lowering vapor temp since I can inhale a lot more at once. But, at the same time, it feels like its far more wasteful when efficiency is concerned. Maybe I just have to conciously take smaller hits when using the PNWT. :ko:

I've found the top holes that allow the water to fall back into the perc chamber seem to get plugged quickly with the tap water I've been using. I'm going to try an ISO clean and then see if distilled water helps eliminate that issue. If its plugging those upper slits, its bound to plug the showerhead slits soon or later.

I feel like the bottom could be a bit 'flatter', when I set it down it feels like it wants to rock back n forth a bit...and just is a tad unstable. Make sure you push it out of the way while you prep. I've bumped it a couple times and it wobbled back n forth on a balance point.

Overall I feel it does a good job of cooling vapor for my needs. Its a bit awkward to use with a log; its just not natural to use my log 'up right'. And if I weren't using an SS or brass bowl, I don't think the herb would 'pack into' and stick to a [larger] glass bowl as well.

Get one of these and you wont have to worry about the bottom not being flat enough

http://fuckcombustion.com/threads/arizer-solo.3833/page-801#post-477984

c90s.jpg
 

tiukauleh

Well-Known Member
Any log-vapers used this, or a similar HydroTube / WaterTool?
I'm assuming to get it to perc properly it has to be held mostly vertical..and generally log vapes aren't held that way due to herb spillage into the chamber. I have a screen over my heat port (like any good log vape should), but still, I don't like herb or essential oils in my chamber gumming tubes up.
Starting to think a perc'd bubbler may have been a better idea is all..hoping I'm proved wrong after I get it and get accustomed with it some.

yeah, using the PWT vertically on a log presents some issue like herb spillage. still, for a little change and those looking for a Da Buddha-like set-up, i sometimes position my log vape horizontally, and attach glass bowl with silicon stem connected to the PWT. kinda like a log vape da-buddha style.
 

MileHighLife

Blower of glass, grower of grass
I've been using mine on my UD a lot ... I really like the low resistance. Once I'm done with my hit I pull the tube to clear while leaving the gong on the heater core. I've just been leaving the gong there between hits too unless I want to stir or if I know I'll be taking a break before the next hit then I'll pull the gong.
 

tiukauleh

Well-Known Member
oh hell, i forgot to ask SOS - water marks inside my PWT that i am unable to get rid off with 99% iso. i cannot get grunge off or what not where i stay - any other suggestions?
 
tiukauleh,

ou812?

Well-Known Member
oh hell, i forgot to ask SOS - water marks inside my PWT that i am unable to get rid off with 99% iso. i cannot get grunge off or what not where i stay - any other suggestions?


also CLR works wonders on hard mineral stains too. Try to use distilled water and some of the other adjuncts that were offered as well to keep it from happening afterwards. CLR, if small rig, a shot glass or 2 worths, (F-bomb,PNWT not even a shots glass I would think) slightly diluted with a bit of water,mechanical agitation and maybe keep it soaking in the can for a while after wards to make sure,shake again dump, rinse with cold tap* ,dump it out flush with distilled and either put her up or fill her up and get going to the bake sale!!:party:

ps wear gloves,if prolonged use,it will cause some irritation,but I have done it with out gloves, and noticed afterwards,skin was real dry and seemed to remove a bit of callouses but nothing ER bound or problematic later on but best to be safe side and avoid contact and do *rinse it out thoroughly.
 

PPN

Volute of Vapor
Hi Guys, I'm trying to order one with the coupon code on vaporblunt website but they don't ship to France, I send us a e-mail to know if it could be possible but i still don't get answer...

This a really nice deal, pnwt for 50 bucks! but frenchies FC menbers wants to get it too....!
 

brucebannor

The Cheshire Cat
Hi Guys, I'm trying to order one with the coupon code on vaporblunt website but they don't ship to France, I send us a e-mail to know if it could be possible but i still don't get answer...

This a really nice deal, pnwt for 50 bucks! but frenchies FC menbers wants to get it too....!

Offer this seller the $50 sale price (but it's $30 shipping to France) and they'll get you one. I think you need to do it today though so don't slack!
 
brucebannor,
  • Like
Reactions: SSVUN~YAH

axakal

Well-Known Member
great vid. i saw that deal, but the people over at the mflb thread got me thinking too much. while i was on the fence, i missed it. never mind, since the new price of 69 dollars isn't that bad either.
could you review this watertool on your blog, in combination with all the portables, that you own? like to step by. :) by the way, you seem to have missed the recent developments around the zenpen grasshopper.

Here is the MFLB with 14.4 mm Micro-shower Water Tool (PNWT)



JNnI1IT.gif
 

S1N3

Tarzan @ KloudSociety
great vid. i saw that deal, but the people over at the mflb thread got me thinking too much. while i was on the fence, i missed it. never mind, since the new price of 69 dollars isn't that bad either.
could you review this watertool on your blog, in combination with all the portables, that you own? like to step by. :) by the way, you seem to have missed the recent developments around the zenpen grasshopper.

Sure can, I'll take a picture this weekend next to the F-bomb when I meet up with @King.
Then get a review up on the pinnacle sometime next week.

I've been tweeting news lately, but you are right about actually creating a news story for the Grasshopper. I've gone and created a post just now highlighting their last three videos and explaining the legal snafu. Have a good one and I appreciate the feedback :)
 

KidFated.

Unknown Member
im almost home then i get to open up my pnwt and test it out..

its fuckin leaking. pissed.
 
Last edited:
KidFated.,

KidFated.

Unknown Member
positive. it leaks out of the female until there isn't enough to touch tha perc.. unless im missing somethin?
 
KidFated.,
Top Bottom