• Do NOT click on any vaporpedia.com links. The domain has been compromised and will attempt to infect your system. See https://fuckcombustion.com/threads/warning-vaporpedia-com-has-been-compromised.54960/.

Cannabis Hardware (formerly NewVape) FlowerPot Twax Vaporizer

Hogni

Honi soit qui mal y pense
What a setup! But for all the noise of the pumps you need a factory building or have to live in the wilderness.
Where does the rosin go? In the dish part of the vac part? Would be a sticky mess I think? Would like to see how to harvest it.
 

Larrytargeteye

Vapin' stevens
Hi boys and girls.it's been ages since I needed to visit the forum because the showerhead is thAt good.I have a question in regards to my coil,will it just stop working or will it degrade in performance gradually?I ask because my bowl of weed doesn't seem to vape as evenly as it used to even after i gave everything a good clean.
 

Alexis

Well-Known Member
Hi boys and girls.it's been ages since I needed to visit the forum because the showerhead is thAt good.I have a question in regards to my coil,will it just stop working or will it degrade in performance gradually?I ask because my bowl of weed doesn't seem to vape as evenly as it used to even after i gave everything a good clean.
Hey bro welcome back. If your coil is defective I would perhaps expect to see some blatant performance differences with the set and coil temp, time to reach temp and stabilize, temp drops during hit etc. I mean once the SH is heat soaked and up to temp steadily, I dont see how the coil itself could be the issue.

Im only assuming this but if everything else in this sense seems just as usual, that doesnt point to the coil being faulty but I dont know anything about coils really. Have a good think though and see if there could be any other factors. The guys here will have some better ideas no doubt.

Maybe your herb is all much drier atm- mine is from the heat. This could slightly alter the way you are extracting from the bowl so that it may be slightly more uneven due to the reduced moisture content in the herb? Just a thought.
 

TheFatBastard

Well-Known Member
Hey guys!

Well, I´m finally about to pull the trigger on the FP SH Twax Starter Kit from Vapefiend: https://vapefiend.co.uk/collections/e-nails/products/flowerpot-twax-starter-kit

I´d also will get a pack of the titanium screens: https://vapefiend.co.uk/collections...ot-20mm-screens-5-pack?variant=12223978438740 (thanks @emmdeemo !)

I´m only vaping flowers, so I guess that´s all I need, since I already have some glass.... anything else you guys think I should get???

As some of yoy may have readed, I´m coming from an Arizer V-Tower, and I was searching for a more intense / psychdelic high, and for what I´ve readed and asked (thanks a lot you guys for all the info and all the PM´s you have replied helping!!!:bowdown:), this is as better as it gets when vaping flowers, so I have to have it :rockon:

Also, please, if you can let me know if there is any discount coupon I can use from Vapefiend, I would really appreciate it, you can PM me or put it here, I´m not buying until next monday.

Thanks again!
 

muunch

hotboxing the cockpit
Hi boys and girls.it's been ages since I needed to visit the forum because the showerhead is thAt good.I have a question in regards to my coil,will it just stop working or will it degrade in performance gradually?I ask because my bowl of weed doesn't seem to vape as evenly as it used to even after i gave everything a good clean.

When you reassembled everything, it may not have come together as tightly (or just the same as it was)

I always make sure the head is hand-tight after cleaning, and I usually recalibrate my PID after taking off the head. Also check and make sure that tightness was retained after heating. Sometimes it gets loose, and if I jiggle the handle, you can hear the coil nut shaking. I just grab a (DRY) dish towel and tighten it til snug

I've had my OG coil for 11 months now, went from Wraparound to Showerhead to Vrod and its all good still.

edit:

I'd recommend 700 to start out at with the vrod. I settled around 715 but I only ran a few loads thru it.

I had absolutely 0 luck in being able to take a dab off the stock quartz dish, even at 777f.

I prefer to do everything at 1 temp so I spend less time clicking buttons and more time enjoying being baked
 
Last edited:

Chris_CH

Company Rep
Company Rep
The new siblings and the new happy family... Its family portrait day here at NV!

10mm Female and 10mm Male FlowerPot Posts

10mmposts-3.jpg


10mmposts-1.jpg
 

MyCollie

Well-Known Member
I had absolutely 0 luck in being able to take a dab off the stock quartz dish, even at 777f.

I prefer to do everything at 1 temp so I spend less time clicking buttons and more time enjoying being baked

Are there any adjustments you could make that would enable you to take a dab?

Has anyone else had the same issue?

I’m going to get started with my VROD setup very soon.

I’m acquiring too many damn vapes, lol.
 

Pyr0

Stoned Roses
Hey guys!

Well, I´m finally about to pull the trigger on the FP SH Twax Starter Kit from Vapefiend: https://vapefiend.co.uk/collections/e-nails/products/flowerpot-twax-starter-kit

I´d also will get a pack of the titanium screens: https://vapefiend.co.uk/collections...ot-20mm-screens-5-pack?variant=12223978438740 (thanks @emmdeemo !)

I´m only vaping flowers, so I guess that´s all I need, since I already have some glass.... anything else you guys think I should get???

As some of yoy may have readed, I´m coming from an Arizer V-Tower, and I was searching for a more intense / psychdelic high, and for what I´ve readed and asked (thanks a lot you guys for all the info and all the PM´s you have replied helping!!!:bowdown:), this is as better as it gets when vaping flowers, so I have to have it :rockon:

Also, please, if you can let me know if there is any discount coupon I can use from Vapefiend, I would really appreciate it, you can PM me or put it here, I´m not buying until next monday.

Thanks again!
You might want to get one (or more) of the double weave screens
https://vapefiend.co.uk/collections/newvape/products/newvape-flowerpot-screen-3103

420 will take £10 off the total
 
Last edited:

muunch

hotboxing the cockpit
Are there any adjustments you could make that would enable you to take a dab?

Use my enail + banger instead? :lol:

Actually the only advice I was given in this thread was to just buy the SiC dish lol. The convective air at 777f was enough to launch me into a bad coughing fit and my dab barely vaporized. I was able to see vapor build in the can after dropping the carb cap on butit wasn't enough for a milk/solid hit
 
muunch,
  • Like
Reactions: JCat

Alexis

Well-Known Member
Thanks!

I saw I picked up (wrongly) the steel ones.

I guess 2 will be OK, one in use while the other gets cleaned.
If you torch them clean they may not last nearly as long. ISO soak may be better. Some people like to leave the screen in the bowl and soak it all together because they have found that frequently removing and replacing the screen can cause a bit of wear and tear.
 

Baron23

Well-Known Member
Hi boys and girls.it's been ages since I needed to visit the forum because the showerhead is thAt good.I have a question in regards to my coil,will it just stop working or will it degrade in performance gradually?I ask because my bowl of weed doesn't seem to vape as evenly as it used to even after i gave everything a good clean.
They usually fail hard. Either the thermocouple or the main power circuit.

As @Alexis said, perhaps the flower you are using is different in some way?
 

Alexis

Well-Known Member
They usually fail hard. Either the thermocouple or the main power circuit.

As @Alexis said, perhaps the flower you are using is different in some way?
I had to wonder Baron. My own herb is drying out so fast now with our hot UK summer (Autos are loving it!:rockon:) and is vaping differently with much better extraction. So it seems logical that the change in the extraction process could simply be highlighting whichever aspect of the setup as a whole is responsible. Or something like that possibly.
 

Baron23

Well-Known Member
I had to wonder Baron. My own herb is drying out so fast now with our hot UK summer (Autos are loving it!:rockon:) and is vaping differently with much better extraction. So it seems logical that the change in the extraction process could simply be highlighting whichever aspect of the setup as a whole is responsible. Or something like that possibly.
Moisture is one factor, but then there is the bud itself. Some flower I have just puts out a lot of vapor and some is more stingy. Just the way of botanicals, I suppose.
 

juxt

Well-Known Member
replacing the screen can cause a bit of wear and tear.
Agreed, most times instead of cleaning with a solvent I use the S&B Mighty cleaning brush and just push into the bowl and twist and grind a bit. It does a remarkable job cleaning the thing, if you start by looking through the bowl and can't see through the screen, this method will open it up, except for the edges near the bowl sides.

This keeps me from having to clean it that often, and i don't waste reclaim by dipping the whole bowl.
 
juxt,
  • Like
Reactions: JCat

Larrytargeteye

Vapin' stevens
Thanks for the feedback.that makes sense about the showerhead being heat soaked.and so does the dry weed theory.I have a spare coil so I will rule that out for sure tonight.thanks again.such a helpful bunch :)
 

MyCollie

Well-Known Member
Would I have better luck dabbing with the new-vape wrap around e-nail with the quartz/SiC dish than the VRod?
 
MyCollie,

Pyr0

Stoned Roses
Speaking of coils what lifespan on average are you daily users that have yours on most of the day seeing? I just got my first controller/coil set from Nv for Sh use.
I've only had my dhgate enail & coil since october, but I'm hoping it lasts a good while longer :p
I have it on a smart plug for the scheduled timer
during the week it's usually on in the evenings from about 4:45pm till 11pm
Over the weekend, if I'm in the house, it's on until I go to bed, so around 16 hours or so per day.
 
Top Bottom