My coil temps ate typically 670-745, depending on bowl choice, load size, strain, point in the load (always temp stepping to extract fully, as vapor drops off each time).
With the smaller bowl @LabPong is recommending above, 670 will give great tasting full milky hits.
The stock bowl I usually start at about 700. But I really dont see how you are going to get a 20 mm coil to be a good fit. 16 mm is almost right, just needs to be a little looser but not much. The tighter and neater it fits and contacts the glass, and more evenly too, the bettet it will hit.
My coil is now hitting much better since I switched to a nubless heater. The coil now rests on the sick clip, it is lower down where the glass heater is wider at the bottom. Hence better contact and it hits a lot better now.
I know @Buds of War is using a coil with the cyclone bowl. I think his preferred temp was just below 700? 680 maybe?
Anyway @PPN good luck rigging something more effective and enjoyable up. For sure there are easier daily drivers. The Elev8r with coil is really for the committed vaporist indeed!
