I haven't looked into strength ratings etc so can't comment. However, make sure it's at least axial.
https://www.kjmagnetics.com/magdir.asp
IIRC this was mentioned here, just can't recall by whom..
Dynavap VapCap
- Thread starter Fenton Mewley
- Start date
I haven't looked into strength ratings etc so can't comment. However, make sure it's at least axial.
https://www.kjmagnetics.com/magdir.asp
IIRC this was mentioned here, just can't recall by whom..
I haven't looked into strength ratings etc so can't comment. However, make sure it's at least axial.
https://www.kjmagnetics.com/magdir.asp
IIRC this was mentioned here, just can't recall by whom..
If you get a magnet make sure it's N48-N50 strength. They cost slightly more but will have more pull for their size.
Hogni
Honi soit qui mal y pense
An old pipe smoker trick! Did it over years. Works good. Wait until the wood is warmed up, a smooth rubbing over the nosal wings, skin fat is melting and diffuses the wood. A short polish and everything is fine.
Dynalowrider
Well-Known Member
lookhigh, put a screen in your cap it adds mass to the cap, holds heat longer. IMHO
Most hardware stores have different size neodymium magnets in a package of ten. They just have different pole orientation. The vapcap may sit half on half off the magnet.
Back when I was a kid a friend, (older gent), was a pipe smoker, (tobacco). He always used nose oil, sebum, to condition the brier.
Most hardware stores have different size neodymium magnets in a package of ten. They just have different pole orientation. The vapcap may sit half on half off the magnet.
Back when I was a kid a friend, (older gent), was a pipe smoker, (tobacco). He always used nose oil, sebum, to condition the brier.
stark1
Lonesome Planet
After each use my Blackwood stem will look pale and discoloured. It certainly has to do with saliva/moisture.
After each use I used to rub my nose a bit with my fingers and apply all-natural NF wax to the stem...
Does the job, but the tip does looks a bit swollen from the moisture and a bit more matte/worn compared to the rest of the stem.
Now with the Omnivap, no more trouble! It should outlast me I think!
Where are those Ti spinning mouthpieces? I would certainly prefer them over the wooden ones or plain wooden stem... Are they in the buckburner cause of the 'M' @Arielle.Dynavap ?
@naturalarmer having read your remedy about "nose oil", "NF wax", etc I assumed the worst, and shied away from picking my nose.
It only just occurred to me that you weren't talking about "snot". Phew! wad a relief!
Stay calm. Have courage. Wait fer click!
Last edited:
jambandphan03
in flavor country
OK, good to know this, I was wondering why my VapCap wanted to only stick to half of my magnet. I have a bunch on the refrigerator, so I just grabbed a couple. I guess I have the Diametrically Magnetized ones. I'll have to look into the Axially, next time I go hunting for them. My magnets still work just fine, it just puts the cap on to one side instead of centering it.I haven't looked into strength ratings etc so can't comment. However, make sure it's at least axial.
https://www.kjmagnetics.com/magdir.asp
IIRC this was mentioned here, just can't recall by whom..
M update, it's out for delivery
didn't get it on my Bday, but today is just as good 
Last edited:
morninglight
Well-Known Member
Thanks I'll definitely look for these attributes.
SSVUN~YAH
You Must Unlearn, What You Have Learned...
Nose Funk?
WakeAndVape
VapeLife X
my eyes hurt after staring at the computer screen for hours trying to make things happen...time for an M break
Lokbok
Well-Known Member
Thanks for the reply. Glad it's not just my imagination. I do think it's way more convenient to stick a glob on a lil nug and put it into my M vs dabbing it perfectly on my Muad Dib, but I did notice I got significantly less medicated with far more wax/shatter with it.
alterego420
Well-Known Member
This may well be old hat but.... I've just realised that the 'digger outer' on the cap makes a perfect spoon for getting kief into your VC 
This may well be old hat but.... I've just realised that the 'digger outer' on the cap makes a perfect spoon for getting kief into your VC
Wow I never thought to try that.
Also check your CCD to make sure oil is not running off the nug, last time I cleaned my Vapcap the screen was caked up pretty gnarly, either from that or vaping bubble. With the concentrate pad there is a lot more surface area for the concentrate to vaporize from.
This may well be old hat but.... I've just realised that the 'digger outer' on the cap makes a perfect spoon for getting kief into your VC
Kief is probably my favorite way to use the VC right now, excellent effect and some incredible flavor too. Super easy to handle too since it's not sticky like wax.
Lokbok
Well-Known Member
Definitely the first thing I made sure if before I even put any concentrates in it. I've had experience trying to vaporize in other devices and pack a thin layer pretty tightly.
SSVUN~YAH
You Must Unlearn, What You Have Learned...
Got my shipment, thanks DynaVap team! The M is a very nice product!
The leapordwood stash fits in nicely! Plus I just noticed my 14mm WoodScents stem fits easily, though w/o the tip. However, I can put the Ti tip in the herb compartment along with spare o-rings and other small accessories. Jackpot!
The M doesn't fit the WoodScents, though you can definitely use it, but it won't rest on top. It also has the older style screens.
The M&M's are easy to spot....
Melts your face and not your hands!
The leapordwood stash fits in nicely! Plus I just noticed my 14mm WoodScents stem fits easily, though w/o the tip. However, I can put the Ti tip in the herb compartment along with spare o-rings and other small accessories. Jackpot!
The M doesn't fit the WoodScents, though you can definitely use it, but it won't rest on top. It also has the older style screens.
The M&M's are easy to spot....
Melts your face and not your hands!
mucsusn
60 going on 20
Just got my 3 new M's. VC's #'s 6, 7 and 8. Burned in the tips, then the tips and caps. Just had my first pull with a 4 second preheat, pause, then heat to click. George, Matt, Arielle......get ready, because the reason I bought 3 is to start passing them out amongst friends for two week trials. I'm going to give them the online resources and of course my tutelage upon their request. Pretty sure this thing, at 50 clams plus a torch, is going to be a game changer. Home run, my dear Vapcap team!Post session edit. Unbelievable for a $50 retail unit. The epitome of engineering meet simplicity. George, I hope that you retire to a green Wisconsin pasture, courtesy of us
Last edited:
Doesn't the FF2 still use a SS concentrate pad?
mucsusn
60 going on 20
Yes, but their proprietary one is thin, but dense. Works perfectly with several consistencies of concentrate brought back from CO. The flavor is unreal, the effect is immediate, and no coughing. I've never experienced a better concentrate session.
jambandphan03
in flavor country
Love the M 
just took it with us out to the woods to shoot pellet air guns (target practice) makes me realize I definitely need a multi flame torch for outdoor use, hard to get a good heat up in the wind with a single flame. The M feels like the grown up version of the Glass unit. It was nice to not fear dropping it, and I had no trouble using it. Like my glass version, I added a pen grip with added carb hole, and one of the rubber mouth pieces so I'm not chomping down on metal. I had to push the mouthpiece all the way down in order to make it fit in the doob tube. Over all, I am very pleased to have this model.
just took it with us out to the woods to shoot pellet air guns (target practice) makes me realize I definitely need a multi flame torch for outdoor use, hard to get a good heat up in the wind with a single flame. The M feels like the grown up version of the Glass unit. It was nice to not fear dropping it, and I had no trouble using it. Like my glass version, I added a pen grip with added carb hole, and one of the rubber mouth pieces so I'm not chomping down on metal. I had to push the mouthpiece all the way down in order to make it fit in the doob tube. Over all, I am very pleased to have this model. 
little maggie
Well-Known Member
My M came today. I can't believe how sturdy it is for such an incredible price. I'd buy more to give to a friend but I've failed at converting her. She's had one of my vapcaps for a month but hasn't tried it yet. Not ready to give up combustion.
If someone is new to these who wants more than one I'd strongly recommend getting 2 M's or an M and one of the others instead of getting the glass and an M.
I haven't tried it yet but if the body doesn't get hot I think it will be fine with the woodscent. Just need to hold the stem upright. A bit like my vaporbrothers mini whip.
If someone is new to these who wants more than one I'd strongly recommend getting 2 M's or an M and one of the others instead of getting the glass and an M.
I haven't tried it yet but if the body doesn't get hot I think it will be fine with the woodscent. Just need to hold the stem upright. A bit like my vaporbrothers mini whip.
cybrguy
Putin is a War Criminal
Well, Duh. I bought a (too) strong magnet about 1.5". There was no option to choose between axial and diametrical so I just assumed it would be axial.I haven't looked into strength ratings etc so can't comment. However, make sure it's at least axial.
https://www.kjmagnetics.com/magdir.asp
IIRC this was mentioned here, just can't recall by whom..
Bad assumption. The magnet is useless for this application. It could, however, easily hold a 1/2" slab of wood to the fridge if that was useful in some way... Oy!
Oh, and BTW, The "M" is here and it looks and feels very nice. I will give her a try tonight...
YaMon
Vaping since 2010
Ordered my 'M' Sat April 1st after 7 PM. Shipping confirmation 12:40 PM Monday! Received, Wed April 1st!!
Out with the old, and it is over 30 years old.. and in with the new M! Thanks Dynavap!
Sorry I could not figure out how to embed that image!
Modnote: Edited to display image
http://fuckcombustion.com/threads/how-to-post-pictures.155/
Last edited by a moderator: